Argos 2147631 ASSEMBLY INSTRUCTIONS

WESTBEACH RAIDER 2.0 STUNT SCOOTER

214/7631

Key Features

6

Instructions for Use

7

the Westbeach scooter

Warning

Warning! not suitable for children under 8 years of age
due to small parts - choking hazard.

• Adult assembly required.

• This product is for children aged 8 years +.

• Maximum total weight 100 kg.

• Always wear a helmet, wrist, knee and elbow pads

when riding your scooter and keep the helmet
chinstrap securely buckled.

• Always wear closed shoes when riding your scooter.

• Ride on smooth, paved surfaces away from motor

vehicles and other road users.

• Avoid sharp bumps, drainage grates, and sudden

surface changes, that might cause the scooter to
suddenly stop.

• Avoid streets and surfaces with water, sand, gravel,

dirt, leaves and other debris. wet weather impairs
traction, braking and visibility.

• Do not ride at night.

• Brake will get hot from continuous use, do not touch

after braking.

• Avoid excessive speed associated with downhill

rides.

• Watch out for pedestrians.

• Check and secure all fasteners before every ride.

• The scooter is designed for one rider at a time.

• Do not use the scooter if it has any damage.

• Replace worn or broken parts immediately.

• Read the information supplied by the manufacturer.

• Do not ride scooter with one hand. Both hands

should be on both handles at all times.

• Adult supervision is required during the initial assem-

bly and maintenance procedures.

•

Injury may occur if the precautions above are not
observed and followed.
Please check the limitation of use according to

•

regulations of road safety.
Important! The self-locking bolts and other

•

self-locking parts may lose their efficiency.

Care

• Keep the product in a dry place. if the scooter gets

wet, dry metal parts to prevent rusting.

• Clean with damp cloth. do not use solvents or

bleaches for cleaning.

• This scooter is equipped with precision bearings

which were filled with lubricant at high pressure during
manufacturing. For this reason, the wheels can only
run easily and quickly when there is a load on the
scooter. The bearings are maintenance free.
The wheels should be replaced when they get worn.

• For your own safety, please use original spare parts

only. Do not make any structural changes.

• No modification other than to the manufacturer's

instruction shall be made.

• Please rotate the bearings and wheels to check if they

are rolling smoothly.

• Clean regularly paying attention to the moving parts,

clearing them of grit and dirt so they move freely.

• Ensure parts specifications are correct with the

dealers if some parts need to be replaced.

• Ensure the front fork, wheels and handlebar are fixed

tightly. You can use a wrench to tighten the locking
nut. Use firm pressure but don’t over tighten.

Trick / Stunt Riding and Warranty

If you ride your scooter in a manner that places large
forces and stresses on the product, the scooter will not
be covered under warranty.
The scooter is designed to meet and exceed applicable
safety standards, however the forces exerted through
extreme riding will cause premature wear to all parts.