
data sheet
The information contained herein is produced in good faith and is believed to be reliable but is for guidance only. ARGCO and its agents cannot
assume liability or responsibility for results obtained in the use of its product by persons whose methods are outside or beyond our control. It is the
user's responsibility to determine the suitability of any of the products, methods of use, or preparation prior to use, mentioned in our literature. It is
the user's responsibility to observe and adapt such precautions as may be advisable for the protection of personnel and property in the handling and
use of any of our products.
FOR MORE INFORMATION CALL ARGCO AT 1-800-854-1015
OR LOG ONTO WWW.ARGCO.COM
Designed to be used as sprinkler head extensions when a drop nipple
length has been cut too short or when the finished ceiling has
changed from its intended location. Using the appropriate
length extension will allow for realignment of the sprinkler head
without removing and recutting the drop nipple.
•Forged brass body
•Hex shape for installation with wrench
•Fire safe
•One piece forged solid brass construction
•Available in 1/2" or 3/4" IPS and several lengths.
•Significant cost savings to the sprinkler installer.
USE THIS PRODUCT AT YOUR OWN RISK. ARGCO WILL NOT PROVIDE FOR REPLACEMENT OF THIS PRODUCT NOR WILL WE BE
RESPONSIBLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES ASSOCIATED WITH THE USE OF THIS PRODUCT. This product
should only be used when no other installation option is available and then only installed under controlled and supervised conditions. This product has neither been tested nor approved by any agency or authority as being a universally accepted product for the extension of sprinklers.
Over-tightening will cause failure of the brass sprinkler extensions in almost every case. By installing this product you acknowledge that you
accept responsibility for use of this product.
Size
x 1/2” length
x 3/4” length
x 1” length
x 1-1/2” length
x 2” length
1/2” IPS
65-20-240
65-20-241
65-20-242
65-20-243
65-20-244
3/4” IPS
65-20-245
65-20-246
65-20-247
65-20-248
65-20-249
SPRINKLER EXTENSIONS
Caution: Do not exceed
15 foot pounds torque.
Over tightening will cause
the sprinkler extension to
crack and leak.