AREC A0030 User Manual

AREC AM-500 Quick Start

Specifications:

AM-500 Wireless Microphone Positioner

Front function key Stop tracking and Mute function

Effective range of microphone A circle of 12 meter radius

Sound input

Power supply AAA dry cell X 2 (Duracell alkaline battery recommended)

Power consumption estimates 6 to 8 hours (Duracell alkaline battery recommended)

Dimension 41.5mm(L)x21.5mm(W)x94mm(H)

Weight 45g

3.5 audio input jack

Wireless microphone positioner information

1. Upper front: Mute button and light indicator

2. Lower front: Stop tracking button and light indicator

3. Upper right side: Power switch and light indicator

4. Lower right side: Wireless mic. pairing light indicator

5. Left side: 3.5 audio input jack

Light indicators of your wireless microphone

AREC wireless mic. Light Color Status

Upper front

Lower front

Upper side

Lower side

Red Muted

Red

Red & Green

Blue

Auto tracking function suspensive

Press and hold for more than 5 sec. to reset to static IP

address and the light flashes red

The light turns green then turns off after power ON

The light turns red when power is low

The light flashes blue intermittently if without paired device

The light flashes blue fast when pairing with one device

The light flashes blue slowly when paired with one device

successfully

Federal Communication Commission interference statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures: -Reorient or relocate the receiving antenna. -Increase the separation between the

equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) this device may not cause harmful interference and

(2) this device must accept any interference received, including interference that may cause

undesired operation

RF Exposure Warning

The equipment complies with RF exposure limits set forth for an uncontrolled environment. The

antenna(s) used for this transmitter must not be co-located or operating in conjunction with any

other antenna or transmitter.

You are cautioned that changes or modifications not expressly approved by the party responsible for

compliance could void your authority to operate the equipment.