ARC Audio XDI 6.2, XDI 5.2 User Manual

INTRODUCTION

XDi S

XDi S

eries

XDi 6.2XDi 5.2

eries

Thank you for choosing ARC Audio’s
hi-performance mobile audio products. We hope you
enjoy your experience with all our products and we
welcome any questions or comments you may have.

XDi SERIES

SPECIFICATIONS

XDi 6.2XDi 5.2

”¼ 5 retemaiD ”½ 6 retemaiD

sttaw 160 rewoP lacisuM sttaw 240 rewoP lacisuM

sttaw 80 rewoP .roN sttaw 120 rewoP .roN

Bd86 ytivitisneS 8dB9 ytivitisneS

-zh65esnopser ycneuqerF
zhK02

mhO 4 .PMI mhO 4 .PMI

”8/5 4 retemaiD tuO tuC ”8/5 5 retemaiD tuO tuC

”2 htpeD gnitnuoM ”½ 2 htpeD gnitnuoM

ycneuqerF

esnopser

-zh55
zhK02

A WORD ON DISTORTION

INSTALLATION MANUAL

Most speaker damage occurs as a result of amplifier
distortion also known as “Clipping”. Clipping occurs
when an amp is driven beyond its maximum rated
output. This kind of distortion can be hard to hear unless
you know what to listen for. Any time you hear a harsh
ear piercing sound at hi volume your amp is probably
clipping.

1

CAUTION:

Please check the suitability of the installation location
before you begin. Do not cut any of the car’s structure.
Pay attention to the mechanism of the window and door.

If you do not have experience with automotive electrical
and mechanical systems contact a professional
installer. Paying a qualified installer is almost always
cheaper then paying a dealership to repair your car.

Remove the grill from the trim ring first then follow the
steps below installation.

1. Place the speaker in the opening with the trim
ring over it.

2. Screw the trim ring through the panel with the
clips beneath.

3. Install the grill into the trim ring. Add a few drops
of glue if necessary.

4. Snap in the finish ring.

THE INSTALL

After you have found the best location for the woofer,
make or enlarge the mounting hole. Make sure the
opening is just large enough for the woofer to fit tightly
with no gaps. Make sure the surface is flat and that
the speaker does not bind up in the opening. Use an
awl or felt pen to mark the panel and drill the screw
holes without the speaker in place. This will save the
costly mistake of punching a hole in one of your new
speakers. Install the woofer with the grill ring using the 4
screws provided with this system. Firmly seat the grill
into its ring.

2 3

GRILL

SCREWS

SPEAKER

GRILL RING

PANEL

CLIPS