Aragon 4-T-2 Owners manual

ARAGON 4T2 AM/FM TUNER OWNER'S INFORMATION

Please read this manual. Upon completion you will understand the set-up and operation of
your 4T2 tuner:

CONNECTIONS
FM - Your Aragon 4T2 tuner contains the MA GIC (Mondial Antenna Ground Isolation Circuit)

-patent pending. This will allow you to connect your tuner to either cable TV /FM or to an
outdoor antenna without any ground induced noise. In addition, it will also serve to protect

your system from lightning damage or build up of static electricity without any signal loss. The
FM antenna is connected via the gold plated F-type connector on the rear panel. If you are
using the "folded dipole" antenna, first connect the dipole to the 300-750hm balun matching
transformer (supplied) and then connect the balun to the FM input.

AM - An AM loop antenna is supplied with the 4T2. Simply attach it to the bracket located on

the rear panel and connect it to the binding posts marked ANT and GND.

Audio - the 4T2 should be connected to your preamp/receiver using any high quality audio

interconnect cable.

AC - the 4T2 should be connected to a 3 prong wall outlet.

OPERATION OF THE 4T2

1. Power - Push to turn on, again to turn off

2. AM/FM - Press to select AM or FM signal band

3. Tuning - Press the right side to tune up the broadcast band, press the left side to tune down.

4. Seek - This button selects the mode of the tuning button. When the Seek button is pressed
the tuner will advance to the next available station, each time the tuning button is pressed.

When Seek is off, the tuner wi/I advance in 200 KHZ (10KHZ-AM) steps.

5. Distant - When the Distant button is pressed, the tuner wi/I switch to mono as well as
disengage the muting circuit, allowing more distant or weak signals to be received with lower

background noise.

6. 9-16 - The 4T2 allows the pre-programming of a total of 16 AM or FM stations. You may

program any combination of AM or FM stations totaling 16. To access the second bank of
presets, simply press the 9-16 button.

7. Memory - This button activates the memory function for the presets (1-8, and 9-16) of the
tuner. Simply choose the channel mode (1-8 or 9-16) using the 9-16 button. Then choose either

AM or FM. Set the tuner to the desired station and press the memory button. The Memory light

wi/I light on the frequency display. During the time it is lit press the channel selector button you
wish to program. The 4T2 wi/I automatically switch between AM or FM, based upon the preset

station buttons you choose.

The Aragon 4T2 tuner should give you many years of trouble free service. Howeve" if you have
any questions regarding the 4T2 or any Aragon product, please phone Mondial Designs Ltd.

at 914-693-8008.

Note: No user serviceable parts inside. Refer servicing to qualified service personnel.

Caution: To reduce risk of electric shock, do not remove cover: