
INSTRUCTIONS MANUAL
RUS

Dynamik Time
:
100 ÷ 240
(MOM), (ON), (OFF)
4, 2 1 / ( 1,5 )
24 ÷ 240
:
1) ( MOM / Priming) ” ,
”.
2) ( ON / Run) ” , ”
””, A_on
””, , Arun
:
A. Batch Dosing ( ):
:
a1. A ( ) 1 60 P ( ) 0.
i) A = 5 P = 0 : 5 ,
;
. Cyclic Dosing ( ): , .
b1. 2) A ( ) P ( ) 1 60
ii) = 5 = 8 : 5 () 8
(), ;
3) ( OFF / Stand-by) ” ”
Time (), :
1) A ( - ) 1 60
2) P ( - ) 0 60
–
Dosing (), :
A = 4 /
B = 2 /
C = 1 /

code: 0000136964 rev. 1.1
(Switch position MOM / Priming) “Pump run for all time long that the switch is pressed”
(Switch position ON / Run) “Wait trigger to start dosing”
Pump waits a “trigger” and the display shows
eives a “trigger”, it start to doseand the display shows
the pump doses for 5 minutes every time a trigger comes;
the pump works for 5 minutes (ON) and stopfor 8 minutes (OFF)
until the trigger is present;
(Switch position OFF / Stand
dosing time) from 1 to 60 minutes
wait time) from 0 to 60 minutes
desired dosing amount according to the season or to the period of use of
Power Supply 100÷240 Vac
Digital Display
Priming (MOM), Run (ON), Stand-by (OFF) mode selectable by switch
Flow rate 4, 2 and 1 l/h (at 1,5 Bar) selectable by programming menù
External trigger 24÷240 Vac
Pump can works in the following two ways:
A. Batch Dosing: the pump starts every time receive the external trigger and work only for the set active time:
a1. set A (activation time) from 1 to 60 min and P (pause time) to 0.
i) Example with A= 5 and P=0 minutes:
Cyclic Dosing: the pump works cyclically until the trigger is present.
b1. 2) set A (activation time) and P (pause time) from 1 to 60 minutes
ii) Example with A= 5 and P=8 minutes:
to adjust flow rate pump:
A = Summer 4 l/h
B = Middle season 2 l/h
C =Winter 1 l/h
Customer may use this function to selectthe