Aquapro Fish Feeders ATX User Manual
AQUAI
®
□ О
S'
j
i
Î
i
s
INCLUDED PARTS
1) Directional Power
Control Unit (1)
2) Mounting Bracket (attached) (1)
3) Clear Disbursement Chute (1)
4) Directional Digital Timer Unit (1)
5) Top Mounting Plates (2)
6) 8MM X %” bolt (4)
7) 8MM X %” Sheet Metal
Screw (4)
8) 8MM X %” Self Tapping
Screws (4)
REQUIRED TOOLS
1) 8MM Nut driver
2) Pliers
3) Cordless or Electric Drill
(if necessary)
4) Vs" drill bit
(if necessary)
5) V4” drill bit
(if necessary)
6) Pen/Marker
(if necessary)
7) 1V2”-2” Hole Saw
(if necessary)
ASSEMBLY INSTRUCTIONS
Verify the contents of the package against the
included parts list. If you are missing any parts
1
from the list, please contact BA Products immediately
at the toll-free number provided.
Remove contents of directional power control
unit box.
2
Turn the box so that the disbursement
opening is facing away from you. (clear side)
3
(Illustration A)
IF MOUNTING ON A AQUA PRO POLY
BARREL.
Locate and align one of the Top Mounting plates
with the mounting holes in the top of the unit.
4
Locate and align one of the Top Mounting plates
with the mounting holes in the top of the unit.
5
(Illustration B)
Repeat step 5 for the other side of box.
(Illustration B)
6
PAGE 2
PAGE 3
Detach the mounting bracket from the unit by
depressing the two retainer ciips and sliding the
7
mounting bracket away from you. (Illustration C)
Now position the mounting bracket over the
hole in the container making sure the hole is
8
the same size as the hole in the top of the unit.
(Illustration D)
Install the four #8 x %” sheet metal screws
into each of the four mounting holes on the poly
9
barrel and tighten. (Illustration D)
Proceed directly to step 16.
10
IF NOT MOUNTING TO A AQUA PRO
POLY BARREL.
/1 ^ Detach the mounting bracket from the
J
___
Lunit by depressing the two retainer clips
and sliding the mounting bracket away from you.
(Illustration E)
i»1 ^ Now position the mounting bracket over the
J-^hole in the container making sure the hole
is 1V2"-2” wide.
/1 OMark the four mounting holes to be drilled.
^OlVIake sure that the metal shutoff lever is
facing toward the front of the feeder in the direction
you wish for the feed to be disbursed. (Illustration F)
Drill the four holes with a V drill bit.
(Illustration G)
14
PAGE 4 PAGE 5
Loading...