Aqua Computer cuplex kryos sTRX4 FC Service Manual
cuplex kryos sTRX4 FC 07/2020
computeraqu
a
cuplex kryos sTRX4 FC
cuplex kryos sTRX4 FC
cuplex kryos sTRX4 FCcuplex kryos sTRX4 FC
Operating and assembly manual
Operating and assembly manual
Operating and assembly manualOperating and assembly manual
1. Preparation
1. Preparation
1. Preparation1. Preparation
Back up your data before modifying your hardware! Disconnect your PC from the mains power outlet. To prevent
damaging the sensitive hardware components, make sure to ground your workplace and yourself to prevent electrostatic discharges.
When upgrading an existing PC setup, remove the installed heat sink from the CPU. Refer to the instruction manual
of the CPU cooler for details. Remove thermal grease residues from the CPU surface using benzine if necessary.
Apply a thin layer of the thermal grease supplied with the cuplex kryos sTRX4 FC using the supplied plastic spatula.
2. Installation
2. Installation
2. Installation2. Installation
Place the cuplex kryos sTRX4 FC on top of the thermal grease covered CPU. Place on spring into each recess and
insert a screw through each spring into the anchor threads of the CPU socket (only one or two revolutions). Alternately fasten each screw a fraction of a revolution until all four screws are fully fastened.
3. Integration into a water cooling system and flow direction
3. Integration into a water cooling system and flow direction
3. Integration into a water cooling system and flow direction3. Integration into a water cooling system and flow direction
Integrate the cuplex kryos sTRX4 FC into a water cooling system of sufficient performance. For best cooling performance, the coolant must be supplied through the upper fitting of the cuplex kryos sTRX4 FC. Reversed flow direction significantly decreases cooling performance.
4. RGBpx illumination (acrylic version only)
4. RGBpx illumination (acrylic version only)
4. RGBpx illumination (acrylic version only)4. RGBpx illumination (acrylic version only)
Optional: Connect the integrated RGBpx illumination module (connector to the left on the long side of the water
block) to a compatible RGBpx output of an Aqua Computer device. A suitable cable is included in delivery. If required, additional RGBpx components can be connected to the connector on the short side (daisy chain).
Compatible products with RGBpx output:
● D5 NEXT (41118)
● farbwerk 360 (53279)
● farbwerk nano (53280, 53281)
● OCTO (53286)
● QUADRO (53256)
An adapter for common motherboard connectors for addressable LEDs can be bought separately, product code
53285.
5. Initial operation and approved coolants
5. Initial operation and approved coolants
5. Initial operation and approved coolants5. Initial operation and approved coolants
Put the water cooling system into operation, but do not connect any other PC components to the mains supply!
Check the cuplex kryos sTRX4 FC as well as the fittings for leakages and do not put your PC into operation unless
you can definitively eliminate the possibility of coolant leaking from the system! If any component has been in contact with coolant, do not put it into operation before it is completely dry again! For operating the PC, the cuplex
kryos sTRX4 FC must be correctly mounted and be connected to a water cooling system featuring adequate cooling
performance! For corrosion inhibition, “Double Protect Ultra” must be used as coolant!
ATTENTION:
ATTENTION:
ATTENTION:ATTENTION:
Disregarding the instructions may lead to severe damages! Aqua Computer GmbH & Co. KG cannot be held li
Disregarding the instructions may lead to severe damages! Aqua Computer GmbH & Co. KG cannot be held li----
Disregarding the instructions may lead to severe damages! Aqua Computer GmbH & Co. KG cannot be held liDisregarding the instructions may lead to severe damages! Aqua Computer GmbH & Co. KG cannot be held li
able for damages or injuries resulting from improper installation or use of the product!
able for damages or injuries resulting from improper installation or use of the product!
able for damages or injuries resulting from improper installation or use of the product!able for damages or injuries resulting from improper installation or use of the product!
Thank you for choosing an aqua computer product.
94907
© 2020 Aqua Computer GmbH & Co. KG – Gelliehäuser Str. 1 – D-37130 Gleichen
Loading...