Aqua Bath P6042BF User Manual

Acrylic Shower Pan

• Model P6042BF – 3/4” Threshold

• Acrylic pan designed for new build and renovations of
existing hospitals, nursing homes, rehabilitation centers,
hotels, motels, dormitories and residential applications.

• Meets ANSI A117.1 and other standards for accessibility.

• Acrylic one-piece molded construction simplifies installation
with a lightweight durable base.

• Inside dimensions: 57¼" W x 40¾" D x 4" H.

• 3/4" threshold height for top of slab installation.

• Patented integral molded in "Trench Drain System" to help
channel water from the front of the unit to the center drain location.

For additional information, call the

Aqua Bath Customer Service

Department At 1-800-232-2284

The P6042BF, as shown, is NOT ADA
compliant. Please see Aqua Bath's line
of ADA compliant shower pans. Please
check with your local city and state for
code compliancy. Aqua Bath accepts no
responsibility for final code compliance.

Acrylic Shower Pan

Aqua Bath Shower Pan P6042BF – 3/4” threshold is molded from a single sheet of cast acrylic so as not to have
any joints or seams. Shall meet ANSI Z124.2 and other standards for accessibility. Unit shall have a backside
flame spread of less than 30 (Class B). Shall be designed to be NAHB LISTED. The enclosure shall have inside
dimensions of 57¼" W x 40¾" D x 4" H and outside dimensions of 60" W x 42" D x 6" H. The unit shall be molded
with a patented integral recessed "Trench Drain System" so as to direct water to the center drain location.
The approximate weight of the unit shall be 55lbs.

The shower pan shall be equipped with the following factory installed accessory: 1) Self-caulking brass drain with
stainless steel strainer (not installed). 2) Ribbed bottom for slip resistance (standard).

AVAILABLE OPTIONS

1) Available in model P6042TD - This unit is the same as the above stated unit except it will have a center front

trench drain located approximately 4" inside of the front flange.

2) ASTM F462 non-slip bottom (see model P6042BF-VB – 3/4” Threshold).
(*) When the ASTM F462 bottom is specified with the center drain location, it will re-configure the trench
drain system. A signed off approval is required for the bottom re-configuration.

Modifications: Received and / or approved by:

P6042BF with 3/4” Threshold - Acrylic Shower Pan

02/05

AQUA BATH COMPANY INC.921 Cherokee Ave.Nashville, TN 372071-800-232-2284Fax [phone]

www.aquabath.com