
Ribbed Bottom For
Slip Resistance
15½" 
31" I.D. 
18" 
31½"
I.D.
For additional information, call the 
Aqua Bath Customer Service 
Department At 1-800-232-2284 
Accessible Series 
Submittal Data 
IS3632SH 7 3/4”
Top View - Left Hand Shown
1" Dia. S.S. Curtain Rod
Important Note: 
Aqua Bath Recommends The Use Of A 
Slide Bar As An Accessory In The Unit Rather
han The Use Of A Glide Bar / Glide Rail.
76"
11½"
84"
83"
80"
38" 
42"
7¾" Threshold 
27½"
36" O.D.
31½" I.D. 
32" O.D. 
ront View and Right Side View
Note: Manufacturing Tolerance Of (±1/4”) Due To The Nature Of The Materials Used 
Installation: Detailed installation instructions are contained in this catalog, and provided with each unit shipped.  
The field installation instructions must be followed as directed or may void manufacturers warranty 
  Reference installation instructions for IS3632SH 7 3/4". 
. 
Page IS-10 
AQUA BATH COMPANY INC.921 Cherokee Ave.Nashville, TN 372071-800-232-2284Fax (615) 227-9446 
www.aquabath.com 
12/08 

ACCESSIBLE SERIES 
•  Model IS3632SH 7 3/4”-L valve on left. 
•  Model IS3632SH 7 3/4”-R valve on right. 
•  Bath units designed for hospitals, nursing homes, rehabilitation 
  centers, hotels, motels and residential applications. 
•  Acrylic one-piece molded construction simplifies installation. 
•  Inside dimensions: 31” W x 31½” D x 78” H. 
•  Can be furnished complete with valve, hand held shower set, 
  curtain and hooks. 
• 7 3/4” threshold. 
•  Vacuum-formed from .1875” one-piece sanitary grade acrylic. 
•  Manufacturing Tolerance Of (±1/4”) Due To The Nature 
  Of The Materials Used. 
Acrylic Shower Stall 
The shower enclosure shall be Aqua Bath model IS3632SH 7¾” acrylic and be molded from a single sheet so as not to have any 
joints or seams, shall meet ANSI Z124.2. Unit shall have a backside flame spread of less than 30 (Class B). 
Shall be designed t o be NAHB LISTED. The enclosure shall have inside dimensions of 31” W x 31½” D x 78” H and outside 
dimensions of 36” W x 32” D x 84” H. Two soap trays molded at 40” above the shower floor on the back wall 
The approximate weight of the unit shall be 205lbs. 
The unit shall be formed with a patented recessed trench system so as to direct water to the center drain. 
Standard Accessories: 
1) One 10½” x 1” diameter, 18 gauge stainless steel towel bar with 1½” safety statute clearance. 
2) 1” diameter, 18 gauge stainless steel curtain rod. After towel bar and curtain rod have been factory installed, they will be 
sealed from the backside making the unit completely waterproof. 
3) Ribbed bottom for slip resistance (standard). 
Available Accessories: 
1) Factory installed fold-up seat. 
2) Hand held shower set (includes 60” flex hose, swivel connector, brass nipple, lock nut, wall outlet and vacuum breaker).    
3) 24” slide bar, 30” slide bar or two (2) wall brackets installed on valve wall for use with hand held shower set.  
Note: The determination of the use of slide bar or wall brackets to be installed in the unit is based upon the valve package 
chosen by the specifier for use in the unit. Aqua Bath recommends the use of a slide bar as an accessory in the unit rather 
than the use of a glide bar / glide rail.
4) Pressure balance or thermostatic control valve. 5) Shower curtain - antibacterial, with hooks. 
6) Weighted shower curtain (patented), antibacterial, with hooks. 7) Seat belt (for the fold-up seat only). 
8) Dome light (factory drilled only, must be field installed and light shipped separately from unit). 
9) ASTM F462 non-slip bottom. (*) When the ASTM F462 bottom is specified with the center drain location, 
it will re-configure the trench drain system. A signed off approval is required for the bottom re-configuration. 
Modifications: 
Received and / or approved by: 
For additional information, call the 
Aqua Bath Customer Service 
Department At 1-800-232-2284 
The IS3632SH 7¾” is NOT ADA 
compliant. Please see Aqua Bath’s full 
line of ADA compliant shower and 
tub/shower units. Please check with 
your local city and state for code 
compliancy. Aqua Bath accepts no 
res
onsibility for final code compliance.
Name:______________________________ 
Company:___________________________ 
Title:_______________________________ 
Phone:______________________________ 
Date:_______________________________ 
AQUA BATH COMPANY INC.921 Cherokee Ave.Nashville, TN 372071-800-232-2284Fax (615) 227-9446 
www.aquabath.com 
12/08