APW Wyott HR-30 Installation Manual

APW/WYOTT EQUIPMENT LIMITED WARRANTY

APW/WYOTT Foodservice Equipment Company warrants its equipment against defects in materials and workmanship,
subject to the following conditions:

This warranty applies to the original owner only and is not assignable.
Should any product fail to function in its intended manner under normal use within the limits defined in this warranty, at the

option of APW/WYOTT such product will be repaired or replaced by APW/WYOTT or its Authorized Service Agency. APW/
WYOTT will only be responsible for charges incurred or service performed by its Authorized Agencies. The use of other
than APW/WYOTT Authorized Service Agencies will void this warranty and APW/WYOTT will not be responsible for such
work or any charges associated with same. The closest APW/WYOTT Authorized Service Agency must be used.

This warranty covers products shipped into the 48 contiguous United States, Hawaii, metropolitan areas of Alaska and
Canada. There will be no labor coverage for equipment located on any island not connected by roadway to the mainland.

TIME PERIOD:

One-year parts, one-year labor, effective from the date of purchase by the original owner. The Authorized Service Agency
may, at their option, require proof of purchase. Parts replaced under this warranty are warranted for the unexpired portion of
the original product warranty only.

EXCEPTIONS:
*Gas/Electric Cookline - Models GCB, GCRB, GF, GGM, GGT, GHP-H, GWW, EBC, EF, EG, EHP, EWW

Three (3) Year Warranty on all component part, except switches and thermostats. (2 additional years on parts only - No
labor on second or third year.)
*Heat Strips - Models FD - Two (2) Year Warranty on element only - No labor second year.
*Glass Windows, Door Seals, Rubber Seals, Light Bulbs, Broiler Briquettes 90 Day Material Only - No labor.

In all cases parts covered by extended warranty will be shipped FOB the factory after the first year.

PORTABLE CARRY-IN PRODUCTS

Equipment weighing over 70 pounds or permanently installed will be serviced on-site as per the terms of this warranty.
Equipment weighing 70 pounds or under, and which is not permanently installed (i.e.; with cord and plug) is considered
portable and is subject to the following warranty handling limitations.

If portable equipment fails to operate in its intended manner on the first day of connection, or use, at APW/WYOTT's option
or its Authorized Service Agency, it will be serviced on-site or replaced.
From day two through the conclusion of this warranty, portable units must be taken or sent prepaid to the APW/WYOTT
Authorized Service Agency for in-warranty repairs. No mileage or travel charges are allowed on portable units after the first
day of use. If the customer wants on-site service they may receive same by paying the travel and mileage charges.

EXCLUSIONS:

The following conditions are not covered by warranty.
*Equipment failure relating to improper installation, improper utility connection or supply and problems due to
ventilation.
*Equipment that has not been properly maintained, calibration of controls, adjustments, damage from im­proper cleaning and water damaged controls.
*Equipment that has not been used in an appropriate manner, or has been subject to misuse or misapplica­tion, neglect, abuse, accident, alteration, negligence, damage during transit, delivery or installation, fire, flood, not or act of
God.
*Equipment that has had the model number or serial number removed or altered.

If the equipment has been changed, altered, modified or repaired by other than a qualified service technician during or after
the warranty period then the manufacturer shall not be liable for any damages to any person or property which may result
from the use of the equipment thereafter.

This warranty does not cover services performed at overtime or premium labor rates. Should service be required at times
which normally involve overtime or premium labor rates, the owner shall be charged for the difference between normal
service rates and such premium rates APW/WYOTT does not assume any liability for extended delays in replacing or re­pairing any items beyond its control.

In all cases the use of other than APW/WYOTT authorized OEM replacement parts will void this warranty.
This equipment is intended for commercial use only. Warranty is void if equipment is installed in other than commercial

application.
THE FOREGOING WARRANTY IS IN LIEU OF ANY AND ALL OTHER WARRANTIES EXPRESSED OR IMPLIED IN-

CLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS AND CONSTITUTES THE ENTIRE LIABIL­ITY OF APW/WYOTT IN NO EVENT DOES THE LIMITED WARRANTY EXTEND BEYOND THE TERMS STATED
HEREIN.

P/n 88939-20, 01/01

FOR FUTURE REFERENCE
Please complete this information
and retain this manual for the life
of the equipment.
MODEL #———————————————————
SERIAL #———————————————————
DATE PURCHASED——————————————
For Warranty Service and/or Parts this
information is required.

IMPORTANT

PRODUCT MANUAL

Safety Instructions

Installation Instructions

Operation Instructions

Maintenance Instructions

Replacement Parts List

HOTROD® Roller Grills

Slanted HOTROD® Roller Grills

Full Menu HOTROD® Roller Grills

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors or

liquids in the vicinity of this or any other appliance.

!

Improper installation, adjustment, alteration, service or maintenance can

cause property damage, injury or death. Read the installation, operating

and maintenance instructions thoroughly before installing or servicing this

APW/WYOTT Foodservice Equipment Co.

Cheyenne, WY 82003

FAX[phone]

WARNING

equipment.

P.O. Box 1829

[phone]

12

THIS MANUAL SHOULD BE RETAINED FOR FUTURE REFERENCE

! CAUTION

These models are designed, built and sold for commercial use. If these models are positioned
so the general public can use the equipment, make sure that all cautions, warnings and oper­ating instructions are clearly posted near each unit so that anyone using the equipment will
use it correctly and not injure themselves or harm the equipment.

! WARNING

CHECK THE DATA PLATE ON THIS UNIT BEFORE INSTALLATION. CONNECT THE UNIT
ONLY TO THE VOLTAGE AND FREQUENCY LISTED ON THE DATA PLATE. CONNECT
ONLY TO 1 OR 3 PHASE AS LISTED ON THE DATA PLATE.

! WARNING

Improper installation, operation, service or maintenance can cause property damage, injury or
death. Read these instructions thoroughly before installing, operating, maintaining or servicing
this equipment.

! WARNING

ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE
PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL CODES.

! WARNING

DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT
SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT.

Install according to the spacing requirements listed in the installation section of this manual.
We strongly recommend having a competent professional install this equipment. A licensed
electrician should make the electrical connections and connect power to the unit. Local codes
should always be used when connecting these units to electrical power. In the absence of
local codes, use the latest version of the National Electrical Code.

Maintenance and repair should be handled by a factory authorized agent. Before doing any
maintenance or repair, contact APW/Wyott.

IMMEDIATELY INSPECT FOR SHIPPING DAMAGE

All containers should be examined for damage before and during unloading. The freight car­rier has assumed responsibility for its safe transit and delivery. If equipment is received dam­aged, either apparent or concealed, a claim must be made with the delivering carrier.
A) Apparent damage or loss must be noted on the freight bill at the time of delivery. It must
then be signed by the carrier representative (Driver). If this is not done, the carrier may refuse
the claim. The carrier can supply the necessary forms.
B) If there is concealed damage or loss, if not apparent until after equipment is uncrated, a
request for inspection must be made to the carrier within 15 days. The carrier should arrange
an inspection. Be certain to hold all contents and packaging material.

Installation and start-up should be performed by a qualified installer who thoroughly read,
understands and follows these instructions.

If you have questions concerning the installation, operation, maintenance or service of this
product, write Technical Service Department APW/Wyott Foodservice Equipment Company,
P.O. Box 1829, Cheyenne, WY 82003.

ITEM DESCRIPTION PART NO. UNIT

15 MOTOR GEAR 217485-10 ALL UNITS
16 DRIVE MOTOR FAN 12065-10 ALL UNITS
18 TIE ROD, SLANT UNITS 217488-20 FOR "-20" UNITS

19 FOOT, RUBBER 217014-61

FOOT, 1" ADJUSTABLE 86621-00

INSERT FOR ADJ. FOOT 84840-00

217488-30 FOR "-30" UNITS
217488-31 FOR "-31" UNITS
217488-50 FOR "-50" UNITS

20 DRIP PAN 217484-20 FOR "-20" UNITS

217484-30 FOR "-30" UNITS
217714-12 FOR "-31" UNITS
217484-50 FOR "-50" UNITS
217714-20 FOR "-45" UNITS
217524-88 FOR "-75 & -85" UNITS

21 ELEMENT RETAINER 217481-00 ALL FLAT "-20, -30, -31, -50"

217490-00 ALL SLANT "-20, -30, -31, -50"
217714-22 FOR "-45 & -75" UNITS
217524-91 FOR "-85" UNITS

22 ELEMENT SUPPORT 217480-00 ALL FLAT "-20, -30, -31, -50"

217491-00 ALL SLANT "-20, -30, -31, -50"
217714-24 FOR "-45 & -75" UNITS

217524-90 FOR "-85" UNITS
23 SCREW, #6-32 X 1-3/4 81139-00 MOTOR HARDWARE
24 #6 LOCK WASHER 85015-00 MOTOR HARDWARE
25 FLAT WASHER 85072-00 MOTOR HARDWARE
26 #6-32 KEPS NUT 84001-00 MOTOR HARDWARE
27 #8-32 X 3/8 HEX HD SCREW 81531-00 FOR ELEMENTS
28 #8-32 X 3/8 PAN HD SCREW 81300-00 FOR BOTTOM PANEL
29 #10-32 KEPS NUT 84171-00 FOR ELEMENT SUPPORTS

2

11