APW Wyott CFHS-16 Installation Manual

INSTALLATION

AND

OPERATING

INSTRUCTIONS

FRY HOLDING BIN

Model: CFHS Series

RETAIN THIS MANUAL FOR FUTURE REFERENCE

WARNING

Improper installation, operation, service, or maintenance can cause property damage and/or result in
personalinjury.Readthismanual thoroughlybefore installing,operating, orservicing thisequipment.

SAFETY PRECAUTIONS

APW Wyott'sequipment is designed, built andsold for commercial use and shouldbe operated
by trained personnel only. Make sure all CAUTIONS, WARNINGS and operating instructions are
clearly posted near each unit to insure proper operation and reduce the chance of personal injury
and/orequipment damage.

Always disconnect power before cleaning or servicing the unit. Surfaces will remain hot after
power has been removed, allow unit to cool before cleaning or servicing. Never clean the unit by
immersing it in water. The unit is not protected against water jets; DO NOT CLEAN UNIT WITH A
WATERJET.Always cleanequipment properlybefore firstuse.

Phone:
Fax: [phone]
Toll Free: [phone]
Website: www.apwwyott.com
E-mail: [e-mail]

[phone]

APW WYOTT

Foodservice Equipment Company

729 Third Avenue, Dallas, TX 75226

P/N: 95000018 9/05

1

TABLE OF CONTENTS

SECTION ITEM PAGE

1 General Information 3
2 Installation 3
3 Operation Instructions 4
4 Cleaning Instructions 4
5 Troubleshooting 4
6 Replacement Parts 5
7 Wiring Diagrams 6
8 Warranty Policy 7

IMPORTANT FOR FUTURE REFERENCE

Please complete this information and retain this manual for the life of the equipment. For
WarrantyServiceand/or Parts,this informationis required.

ModelNumber SerialNumber DatePurchased

Notes:

2

Check the rating label for your model designation and electrical rating. Rating Label is located on

therear base ofthe unit.

Overall dimensions:

1. GENERAL INFORMATION

CFHS-16

Electrical ratings:

Power Cord:

Shipping Weight:

CFHS-21

22.31

(56.67 cm)

CFHS-16
CFHS-21

6 foot, 3 wire grounded cord. If the supply cord is damaged, the
manufacturer or an authorized service agent or a similarly qualified person
mustreplace it inorder toavoid a hazard.

CFHS-16
CFHS-21

120VAC, 880W, 60Hz, 7.33A, NEMA 5-15 Plug
120VAC, 1130W, 60Hz, 9.42A, NEMA 5-15 Plug

40.0lbs. (18.14 kg)

50.0lbs. (22.68 kg.)

22.70

(57.66 cm)

2. INSTALLATION

The Fry Holding Station is shipped with the ribbon (model CFHS-21 only), divider and trivet
assembled. Care should be taken when removing unit from box, as ribbon, divider and trivet are
free to move.

1. Removeunit from shipping containerwhile inthe upright position.

2. Removeall internal packaging.

3. Inspect bin area for damage. This includes ceramic elements and light
bulbsin overhead assembly.

4. If unit needs to be wiped down please use damp cloth with warm
water.

5. Unitshould now have componentsin place as shown inFigure 1.

6. Placeunit in operatinglocation.
:

Note

Make sure that the operating location is in an area where the
ambient temperature is held constant (minimum 70°F). Please
avoid areas such as near exhaust fans, hoods and air conditioning
ducts.

Warning

Ensure thatoperation location is ata reasonable distancefrom combustible walls andmaterials
otherwisecombustion ordiscoloration couldoccur.

Caution

Place unit on a stable counter ata convenient height for use. The lidof the FryHolding Stationis
not intended to be used as a shelf. Objectsover 25lbs (11.33kg)should not be placed on top of
unit.

7. Beforeplugging unitinto wall, makesure thatthe switchis in theoff or0 position.

8. Plugunit intogrounded electricaloutlet withcorrect voltage,and plugconfiguration.

Ambient Conditions

:

Operating environment

:

Operating environment

Figure 1.

3

3. OPERATION INSTRUCTIONS

1. TheOn/Off switchshould bein the offlineposition0.

2. Flipswitch to onlineposition I.

Caution

The unit's externalsurface temperatures will be hot. Usecaution when touching these areas to
avoidinjury.

Warning

Ceramic elements operate at high temperatures.

applied to the elements red color
changing decal

to black. The decal will remain black until the element falls below the transition temperature
where it will then return to its original red color. However, the element even if red will still be
extremelyhot. This color changing decal is used onlyfor determiningif elementis operational.

:

External Surface Temperatures

:

Severe Burns -Ceramic Elements

. Incorporated into the front surface of the element is a

. As the element reaches a certain temperature the decal will change from red

4. CLEANING INSTRUCTIONS

Do not touch elements after power is

Warning

Before cleaning, ensure that the unit is unpluggedand its components are cooled down. There should be no
powergoing to theunit.

Warning

Never spray water on the unit or controls nor submerge unit in water. Damage to the unit as well as injury
couldoccur.Injuryand burns mayoccurif youdo not followthis instruction sheet.

Cleaning should bedone Daily.

1. Cleanoutside withwarm soapy water and asoft clothonly. Milddegreaser canbe used. Do not use
abrasivecleaners, asthey will scratchthe finish,which couldinduce dirtaccumulation.

2. solventsor acetonetype cleaner. They will damagethe sealant.

3. Once a week, clean the inside of the cabinet with warm soapy water and a soft cloth only. Mild

DO NOT USEANY

degreasercan be used.

:

UnplugPower

:

Cleaning

5. TROUBLESHOOTING

Always ask and check the following:

1. Is the unit connected to a live power source of the proper voltage?

2. Check the circuit breaker.

3. Is power switch ON and lights glowing?

4. Check the rating label. Is the unit connected to the correct power source?

5. If the above checks out, and you still have problems, call your local service agent.

4

6. REPLACEMENT PARTS

EXPLODED VIEW

1

7

2

3

4

5

6

REPLACEMENT PARTS LIST

ITEM PART NUMBER DESCRIPTION QUANTITY

1 75916 Lamp, 40w, Teflon Coated 2
2 95000026 Element, Ceramic, CFHS-21 2

95100006 Element, Ceramic, CFHS-16 1
3 95000035 Divider, Trivet 1
4 95000005 Trivet, CFHS-21 1

95100021 Trivet, CFHS-16 1
5 95000036 Ribbon, 6 Bag (CFHS-21 only) 1
6 95000046 Pan w/Bottom Heater, CFHS-21 1

95100020 Pan w/Bottom Heater, CFHS-16 1
7 89488 Switch 1
8 95000041 Thermostat (Not Shown) 1

5

OVERHEAD

7. WIRING DIAGRAMS FOR CFHS SERIES

CFHS-21

RACEWAY

5

N
L

6

1

2

NL

N

3

L

4

BASE

(BLUE)

(BROWN)

9

N

L

3

4

L

7

7

8

L

OVERHEAD

BASE

G

L

CFHS-16

RACEWAY

3

N
L

N

2

L

1

4

(BLUE)

7G

(BROWN)

N

L

2

1

L

5

6

N

G

L

L

8. APW WYOTT EQUIPMENT LIMITED WARRANTY

APW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the
following conditions:

This warranty applies to theoriginalowner only and is not assignable.
Should any product fail to function in its intended manner under normal use within the limits defined in this warranty,at the option of

APW Wyott such product will be repaired or replaced by APW Wyott or its Authorized Service Agency. APW Wyott will only be
responsible for charges incurred or service performed by its Authorized Service Agencies. The use of other than APW Wyott
Authorized ServiceAgencies will void this warranty and APW Wyottwill not be responsible for such work or any charges associated
with same. The closestAPWWyottAuthorized ServiceAgentmustbeused.

This warranty covers products shipped into the 48 contiguous United States, Hawaii, metropolitan areas ofAlaska and Canada. There
will be no labor coverage forequipment located on any island notconnected by roadway to the mainland.

Warranty coverage on products used outside the 48 contiguous United States, Hawaii, and metropolitan areas of Alaska and Canada
may vary.Contactthe internationalAPWWyottdistributor,dealer,orserviceagency for details.

TimePeriod

One year for parts and one year for labor, effective from the date of purchase by the original owner. The Authorized Service Agency
may, at their option, require proof of purchase. Parts replaced under this warranty are warranted for the un-expired portion of the
original product warranty only.

Exceptions

Inall cases, parts covered byextended warranty will be shipped FOBthe factory after the first year.

Portable Carry In Products

Equipment weighing over 70 pounds or permanently installed will be serviced on-site as per the terms of this warranty. Equipment
weighing 70 pounds or under, and which is not permanently installed, i.e. with cord and plug, is considered portable and is subject to
the following warranty handling limitations. If portable equipment fails to operate in its intended manner on the first day of
connection, or use, at APWWyott'soptionor itsAuthorized ServiceAgency,itwillbeserviced on site or replaced.

From day two through the conclusion of this warranty period, portable units must be taken to or sent prepaid to the APW Wyott
Authorized Service Agency for in-warranty repairs. No mileage or travel chargesareallowed on portable units afterthefirst day of use.
If the customer wants on-site service, they may receive same by paying the travel and mileage charges. Exceptions to this rule: (1)
countertop warmers and cookers, which arecovered under theEnhanced WarrantyProgram, and (2)toasters or rollergrills whichhave
instore service.

Exclusions

The following conditions arenotcovered by warranty:

If the equipment has been changed, altered, modified or repaired by other than an Authorized Service Agency during or after the
warranty period, then the manufacturer shall not be liable for any damages to any person or to any property, which may result from the
use of the equipment thereafter.

This warranty does not cover services performed at overtime or premium labor rates. Should service be required at times which
normally involve overtime orpremium labor rates, theowner shall be charged for thedifferencebetween normal service rates and such
premium rates.APWWyottdoesnotassume any liability for extended delaysin replacing or repairing anyitemsbeyond its control.

Inall cases, the use of other thanAPWWyottAuthorized OEM Replacement Partswill void this warranty.
This equipment is intended forcommercial use only.Warranty isvoidifequipment is installed inotherthancommercial application.

WaterQualityRequirements

Water supply intended for a unit that has in excess of 3.0 grains of hardness per gallon (GPG) must be treated or softened before
being used. Water containing over 3.0 GPG will decrease the efficiency and reduce the operation life of the unit.

Note: Product failure caused by liming or sediment buildup is not covered under warranty.
THE FOREGOING WARRANTY IS IN LIEU OFANYAND ALL OTHER WARRANTIES EXPRESSED OR IMPLIED

INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR PARTICULAR PURPOSES
AND CONSTITUTES THE ENTIRE LIABILITY OFAPWWYOTT. IN NO EVENT DOES THE LIMITED WARRANTY
EXTEND BEYOND THE TERMS STATED HEREIN.

*Gas/Electric Cookline:

component parts, except switchesand thermostats. (2 additional years on parts only.Nolabor on second or third year.)

*BroilerBriquettes,
*Heat Strips:
*GlassWindows, Doors, Seals, RubberSeals,Light Bulbs:

*Equipment failure relating to improper installation, improper utility connection or supply and problems due to
ventilation.
*Equipment that has not been properly maintained, calibration of controls, adjustments, damage from improper cleaning
and water damage to controls.
*Equipment that has not been used in an appropriate manner, or has been subject to misuse or misapplication, neglect,
abuse, accident, alteration, negligence, damage during transit, delivery or installation, fire, flood,riotoract of god.
*Equipment that has the modelnumber or serial number removed oraltered.

Models FD, FDL, FDD, FDDL. Two(2)YearWarranty onelement only. Nolabor second year.

Models GCB, GCRB, GF, GGM, GGT, CHP-H, EF, EG, EHP. Three (3) Year Warranty on all

RockGrates,Cooking Grates, BurnerShields, Fireboxes:

90Day Material Only. No Labor.

90DayMaterial Only.NoLabor.

9/05

7

Phone:
Fax: [phone]
Toll Free: [phone]
Website: www.apwwyott.com
E-mail: [e-mail]

[phone]

APW WYOTT

729 Third Avenue

Dallas, TX 75226

8