VIAMASTER™ LED LUMINAIRES FOR NEC AND CEC GOVERNED LOCATIONS
Bring LED simplicity and reliability to the entire plant. Compact and easy to install, Appleton® Linear LED luminaires t the
same footprint as a uorescent xture. They perform for at least 60,000 hours. And they deliver more lumens per watt
compared to uorescent tubes – year after year
• 60,000+ hour LED life for years of maintenance
free operation.
• Lightweight design, hinged cover with captive
screws, and terminal block wiring for easy
installation and maintenance.
• Standard screw-type terminal block can accept
UL/CSA 26 to 10 AWG wire.
• Contemporary, low prole design suitable for
tight spaces.
• Field replaceable LED driver and lens.
• Industry-leading thermal management for safe,
reliable operation over wide temperature range.
• Full range of lumen outputs, with light
distribution equivalent to Appleton’s FV Series
uorescent xtures
• Easy to retrot in same mounting footprint as
Appleton’s FV Series uorescent xtures.
• 2 opposing 3/4” NPT hubs with adjacent terminal
blocks for thru wiring. (1) 3/4” NPT close up plug
provided.
SUITABLE LOCATIONS
• For use in locations where:
— Flammable gases, vapors and dusts are present
— A high degree of corrosion resistance is
required
— Protection against dirt, water and moisture is
necessary
• Typical applications include:
— Oil reneries
— Petrochemical facilities
— Pulp and paper mills
— Food processing plants
— Waste and sewer treatment
— Underground tunnels
— General manufacturing facilities
STANDARD MATERIALS
• Housing: copperfree (4/10 of 1% max.)
aluminum
• Lens: thermal shock- and impact-resistant
polycarbonate lens
• Gasket: silicone rubber, mechanically
secured
• Bolts: stainless steel
• Close up plugs: nickel plated brass
— Mounting hardware: See ordering
information
STANDARD FINISHES
• Housing: gray polyester
NEC/CEC RATINGS
• Class I, Division 2, Groups A, B, C, D
• Class I, Zone 2, Group IIC
• Class II, Division 2, Groups F, G
• Zone 22, Group IIIB
• Class III
• Type 3R, 4, 4X
• Marine Outside Type- For USA Only
• IP66/67
• Suitable for Use in Wet Locations
NEC/CEC CERTIFICATIONS AND
COMPLIANCES
• UL Standard: UL 1598, UL 8750,
UL 844
• cCSAus Certied: 065182
• cULus Certied: E10444
• Ambient Temperature:
— LU - Universal Voltages:
120-277 Vac, 50/60 Hz
-40 °C up to +65 °C
(-40 °F up to +149 °F)
— BH - Universal Voltages:
347-480 Vac, 50/60 Hz
-40 °C up to +65 °C
(-40 °F up to +149 °F)
Fusing option not available with Marine Outside Type (Salt Water) rating. Fusing option not permitted for cUL.
Appleton Grp LLC d/b/a Appleton Group. The Appleton and Emerson logos are registered in the U.S. Patent and Trademark Ofce.
All other product or service names are the property of their registered owners. © 2017, Appleton Grp LLC. All rights reserved.
VIAMASTER™ LED LUMINAIRES FOR NEC AND CEC GOVERNED LOCATIONS
Fixing Brackets
for Surface
Installation
FEFBS
Surface
Mounting
Bracket
FESBA / FESBS
LLEDA12- 2K lumen
Clear 120-277VAC LLEDA12LU2
Diffused 120-277VAC LLEDA12LU2D
Clear 347-480VAC LLEDA12BH2
Diffused 347-480VAC LLEDA12BH2D
Surface
Mounting
Bracket
FVSM
Hinged Brackets
FEHBA
LLEDA15- 5K lumen
Clear 120-277VAC LLEDA15LU2
Diffused 120-277VAC LLEDA15LU2D
Clear 347-480VAC LLEDA15BH2
Diffused 347-480VAC LLEDA15BH2D
Fixed 45° Wall
Mount
FVWFM
M8 Ring Bolts
Brackets for Pole
FERBM8Z
LLEDA17- 7K lumen
Clear 120-277VAC LLEDA17LU2
Diffused 120-277VAC LLEDA17LU2D
Clear 347-480VAC LLEDA17BH2
Diffused 347-480VAC LLEDA17BH2D
Standard Catalog Numbers LLEDA12LU2 LLEDA15LU2 LLEDA17LU2
Voltage
Range
LED
Lumens
LU 120 – 277 Vac, 50/60 Hz
BH 347 – 480 Vac, 50/60 Hz
Clear 2,200 4,400 7,800
Diffused 1,800 3,800 6,400
Input Power (W) 22 45 81
Efficacy (LPW) 100 98 96
Ambient Temperature
-40 °C up to +65 °C
(-40 °F up to +149 °F)
T-Rating T4 @ +65 °C (+149 °F)
Correlated Color Temperature (CCT) 5650
Color Rendering Index (CRI) 70
Fixture Length 0.6 m (2 ft) 0.6 m (2 ft) 1.2 m (4 ft)
Fixture Weight 6.1 kg (13.7 lbs) 6.4 kg (14 lbs) 9 kg (19.15 lbs)
Housing: copperfree aluminum
Standard Materials
Finish: gray polyester
Lens: thermal shock- and impact-resistant polycarbonate lens
Lifetime 60,000+ hours
Half Clamp
Mounting
FEHC
Fixture comes with (2) 3/4” NPT conduit entries.
To order with the 347-480 Vac voltage, change the 8th and 9th letters in the catalog number from LU to BH; example: LLEDA15BH2F.
For optional safety cable, add the suffix C to the end of the catalog number; example: LLEDA12LU2C.
For optional fuse, add the suffix F to the end of the catalog number; example: LLEDA12LU2F
VIAMASTER™ LED SERIES EMERGENCY BATTERY BACKUP LUMINAIRES
Appleton® Linear LED luminaires provide over 1,000 lumens of illumination for 90 minutes of emergency lighting.
Compact and easy to install, they t the same footprint as their uorescent counterparts with all the benets LED
has to offer — year after year
• Provides up to 1250 lumens illumination for 90
minutes of emergency lighting.
• Functional diagnostic test self-initiates every 14 days
after initial start up.
• Duration test is automatically performed once per
year.
• Green and Red LED lamps indicate charging status
and provide fault warning.
• Positive safety switch disconnects power to LEDs
and LED driver to allow maintenance in hazardous
locations.
• 60,000+ hour LED life, for years of maintenance free
operation.
• Universal, high efciency, driver covers voltage
requirements for 120-277 Vac, 50/60 Hz +/- 10%.
• Standard 2KV surge suppression.
• Hinged cover with captive screws, and terminal
block wiring for easy installation and maintenance.
• Standard screw-type terminal block can accept UL/
CSA 26 to 10 AWG wire.
• Contemporary, low prole design suitable for tight
spaces.
• Field replaceable LED driver, battery management
module (BMM), battery pack, and lens.
• 5 Cell NiMH battery pack for longer emergency
capability.
• Plug in connectors on battery pack for easy
maintenance.
• Industry-leading thermal management for safe,
reliable operation over a wide temperature range.
• Easy retrot in same mounting footprint as
Appleton’s FV Series uorescent xtures.
• Full range of lumen outputs, with light distribution
equivalent to Appleton’s FV Series uorescent
xtures.
Fusing option not available with Marine Outside Type (Salt Water) rating. Fusing option not permitted for cUL.
• 2 opposing 3/4” NPT hubs with adjacent
terminal blocks for thru wiring. (1) 3/4”
NPT close up plug provided.
SUITABLE LOCATIONS
• For use in locations where:
— Flammable gases, vapors and dusts are
present
— A high degree of corrosion resistance is
required
— Protection against dirt, water and
moisture is necessary
• Typical applications include:
— Oil reneries
— Petrochemical facilities
— Pulp and paper mills
— Food processing plants
— Waste and sewer treatment
— Underground tunnels
— General manufacturing facilities
STANDARD MATERIALS
• Housing: copperfree (4/10 of 1% max.)
aluminum
• Lens: thermal shock- and impact-resistant
polycarbonate lens
• Gasket: silicone rubber, mechanically
secured
• Bolts: stainless steel
• Close up plugs: nickel plated brass
— Mounting hardware: See ordering
informations
STANDARD FINISHES
• Housing/Reector: gray polyester
NEC/CEC RATINGS
• Class I, Division 2, Groups A, B, C, D
• Class I, Zone 2, Group IIC
• Class II, Division 2, Groups F, G
• Class III
• Zone 22, Group IIIB
• Type 3R, 4, 4X
• Marine Outside Type- For USA Only
• IP66/67
• Suitable for Use in Wet Locations
NEC/CEC CERTIFICATIONS AND
COMPLIANCES
• UL Standard: UL 1598, UL 8750,
UL 844
• cULus Certied: E165014
• Ambient Temperature:
120-277 Volts:
-20 °C up to +55 °C
(-4 °F up to +131 °F)
Appleton Grp LLC d/b/a Appleton Group. The Appleton and Emerson logos are registered in the U.S. Patent and Trademark Ofce.
All other product or service names are the property of their registered owners. © 2017, Appleton Grp LLC. All rights reserved.
VIAMASTER™ LED SERIES EMERGENCY BATTERY BACKUP LUMINAIRES
Automatic Testing System (ATS)
Functional Full Duration
Starts within 24 to 45 hours after the initial powerup of the module Starts within 14 to 35 days after the initial power of the module
Occurs every 14 days after the initial aforementioned functional test Occurs every 364 days after the initial aforementioned functional test
Lasts for 5 minutes Lasts for the full duration of the rated emergency period
At the completion of functional and full duration tests, LED indicator will display the status of the emergency luminaire when AC is present
LED Indicator LED Array
Standard Catalog Numbers LLEDA12LU2H LLEDA15LU2H LLEDA17LU2H
Voltage Range LU 120 – 277 Vac, 50/60 Hz
LED Lumens
Standard Operation
LED Lumens
Emergency Operation
Clear 2,200 4,400 7,800
Diffused 1,800 3,800 6,400
Clear 1,250
Diffused 1,000
Input Power (W) 24 45 83
Efficacy (LPW) 92 98 94
Ambient Temperature
-20 °C up to +55 °C
(-4 °F up to +131 °F)
T-Rating T3C @ +65 °C (+149 °F) T4 @ +65 °C (+149 °F)
Correlated Color Temperature (CCT) 5650
Color Rendering Index (CRI) 70
Fixture Length .843 m (33.2 in) .843 m (33.2 in) 1.2 m (47.2 in)
Fixture Weight 8.75 kg (19.3 lbs) 8.89 kg (19.6 lbs) 9.07 kg (20.0 lbs)
Housing: copperfree aluminum
Standard Materials
Finish: gray polyester
Lens: thermal shock- and impact-resistant polycarbonate lens
Lifetime 60,000+ hours
For optional safety cable, add the suffix C to the end of the catalog number; example: LLEDA12LU2C.
For optional fuse, add the suffix F to the end of the catalog number; example: LLEDA12LU2F
Loading...