Appleton Instruction Sheet: Wallmaster HPS/PSMH Luminaires, 654033005 | Appleton Manuals & Guides

654033-005

INSTRUCTION SHEET

CAUTION: This fi xture is designed for permanent installation in ordinary (Non-Hazardous) or wet locations in accordance

with the National Electrical Code and all applicable local codes. Do not use in areas of limited ventilation or in high ambient
enclosures. The lamp and fi xture operate at high temperatures, contact with combustible material can cause fi re and
personal contact can cause severe burns.

Wallmaster™ HPS/MH Luminaires: Vertical Wall Mount.

For 150, 100, 70, 50 and 35 Watt HPS and 100 watt MH HID Lamps

Your vertical mounted Wallmaster comes complete and ready to install.
Before installing, check fi xture for damage.

Caution:

1. Be certain that the electrical power is disconnected before you install fi xture.

2. Check that input voltage is the same as fi xture voltage stated on ballast leads.

FIGURE NO. 1

COMPLETE
ASSEMBLY

FIGURE NO. 5

FIGURE NO. 2

FRONT
COVER

FIGURE NO. 6

BALLAST
ASSEMBLY

FIGURE NO. 3

HOUSING
ASSEMBLY

1

15

/8”

FIGURE NO. 4

BALLAST ASSEMBLY

CAPACITOR

STARTER

JUNCTION BOX

WALL

8 7/8”

13

9

/16”

NOTE: USE SUPPLY WIRE SUITABLE FOR 90ºC FOR 100, 70, 50 & 35 WATT FIXTURES.

1. Remove front cover (Fig. 2) from housing (Fig. 3) by loosening (2) captive screws. Pivot front cover approx. 90º and align
housing hinge tab with slot on front cover (see Fig. 5). Push cover to the right to remove cover from housing.

2. Before proceeding with installation, remove all shrink wrap packaging and check caution Note #1. Loosen ballast plate
screws and swing ballast plate out to rest on refl ector. Install housing to wall with input leads pulled into housing approx. 6”
(See Fig. Nos. 4 & 6).

3. Connect ground lead (GREEN) to green ground screw furnished in housing.

4. Warning - Risk of Electric Shock! - High temperature in fi xture. Fiberglass sleeving must be used over the incoming sup­ply leads to protect them from high temperature. Cut supply leads so that entire length is covered by sleeving, and tie a
knot in leads to retain sleeving. Connect proper ballast line lead to power supply lead, and ballast common lead to supply
common lead. Make sure to position connections in junction box and not inside housing. (Check Caution Note #2.)

5. Close ballast assembly. Tighten screws.

6. Re-Assemble front cover (Fig. 2) to housing (Fig. 3) by reversing procedure described in step #1 (See Fig. 5).

7. Install proper lamp, close cover and tighten hardware.

8. Warning: Use silicone caulking compound around perimeter of fi xture between fi xture and mounting surface and around
conduit fi tting to provide a watertight seal.

EGS Electrical Group • 800-621-1506 • www.appletonelec.com Rev. D 12/27/99 Page 1