Apotop i-Selfie User Manual

Selfie Remote Controller

使用說明

FCC ID :
JY8-BT001

1. 進入iPhone的設定，開啟藍牙

2. 長按 i-Selfie的按鈕，直到
LED閃爍之後放開。

3.「裝置」偵測到「i-Selfie」，
點 選進行配對。

4. 選擇「Pair」之後，LED
停止閃爍，配對完成，裝置
顯示「已連線」。

5. 開啟iPhone相機，按下按鈕
即可拍照。

NCC警語

第十二條：

經型式認證合格之低功率射頻電機，非經

許可，公司、商號或使用者均不得得擅自

變更頻率、加大功率或變更通原計之特性

及功能。

第十四條：

低功率射頻電機之使用不得影響飛航安全

及干擾合法通信；經發現有干擾現象時，

應立即停用，並改善至無干擾時方得繼續

使用。

前項合法通信，指依電信法規定作業之無

線電通信。低功率射頻電機須忍受合法通

信或工業、科學及醫療用電波輻射性電機

設備之干擾。

Selfie Remote Controller

User’s Guide

FCC ID :
JY8-BT001

1. On your iPhone, Go to Settings >

turn on Bluetooth

2. Tap and hold the button of i-Selfie,

until the LED light blinked

3. When iPhone detects i-Selfie, tap

it to connect two device

4. Chose “ Pair ” When LED light

stop blinking, the match is finished,

iPhone displays

5. Go to iPhone camera, and press

the button on i-Selfie, which can

take a photo by i-Selfie.

FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:(1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, according to
Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try correct the interference by one or more of the
following measures:

1. Reorient the receiving antenna.

2. Increase the separation between the equipment and
receiver.

3. Connect the equipment into and outlet on a circuit
different from that to which the receiver is connected.

4. Consult the dealer or an experienced radio/TV
technician for help.
Any special accessories needed for compliance must be
specified in the instruction manual.

Warning: A shielded-type power cord is required in order
to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception.
It is essential that only the supplied power cord be used.
Use only shielded cables to connect I/O devices to this
equipment.
CAUSION: Any changes or modifications not expressly
approved by the party responsible for compliance could
void your authority to operate the equipment.