Apollo Conbraco 59-300 Installation Manual

INSTALLATION
1. Ensure compatibility between strainer materials and media being used.
2. Make sure that the strainer and piping are adequately supported and properly aligned.
3. Make sure all pipe end connections are clean and free of any debris.
4. Apply pipe sealant (pipe dope, Teflon® tape, Loctite®, etc.) to the male end pipe prior to installing the strainer.
5. Make sure the arrow on the body corresponds with the direction of flow.
7. Check the system for leaks prior to putting the strainer(s) in service.
MAINTENANCE
1. Periodic cleaning is essential in any strainer installation.
2. It is recommended to install pressure gages on both the inlet and outlet side of the strainer to aid in determining the need to clean the screen.
3. When the screen becomes 50% clogged, the pressure drop will normally double that of a clean screen. The pressure drop should not be allowed to go over 30 psig.
4. If a problem should arise or a screen requires cleaning or replacement, do not disassemble the strainer while the line is under pressure.
5. Repair kits are available for most models should the screen need replacing.
SCREEN REPLACEMENT
1. Depressurize and drain system.
2. Drain body by loosening cap, removing drain plug or opening ball valve.
3. Remove cap from strainer.
4. Remove old screen and clean or discard.
5. Replace O-ring of PTFE gasket.
6. Push screen into position in cap.
7. Line-up screen and start cap into body by hand.
8. After cap is finger tight, tighten a minimum of 2 turns with wrench.
9. Reinstall ball valve of plug using thread compound or sealant.
10. If leakage occurs under test, return to step 1.
THIS PRODUCT MEETS THE REQUIREMENTS OF THE EPA SAFE DRINKING WATER ACT
WARNING! This product contains chemicals known to the State of
California to cause cancer and birth defects of other reproductive harm. (California law requires that this warning be given to the consumers in the State of California.) For more information visit www.apollovalves.com
Valves
Conbraco Industries Incorporated
1418 S. Pearl St.
Pageland, South Carolina 29728
I-8533-00
Made in USA
Loading...