Apollo Conbraco 500 Installation Manual
Document Number:
ES-1196-1
Revision Level:
D
Issued By:
T. HAMILTON
Date:
3/3/16
Approved By:
Date:
INDUSTRIES, INC.
500 SERIES - SAFETY VALVE
INSTALLATION, OPERATION, & MAINTENANCE
Part I
Conbraco Industries, Inc.
P.O. Box 247
Matthews, NC 28106
(704) 841-6000
Fax (704) 841-6020
http://www.conbraco.com
2
Table of Contents
Series
510
520
530
540
Body
Trim
Bronze
Brass
Bronze
Stainless Steel
Carbon Steel
Stainless Steel
Stainless Steel
Stainless Steel
Max. Set
Steam
250 psi (1724 kPa)
300 psi (2068 kPa)
900 psi (6205 kPa) D/E
600 psi (4137 kPa) F/G
500 psi (3447 kPa) H/J
900 psi (6205 kPa) D/E
600 psi (4137 kPa) F/G
500 psi (3447 kPa) H/J
Max. Set
Air/Gas/Liquid
300 psi (2068 kPa)
900 psi (6205 kPa) D/E
600 psi (4137 kPa) F/G
500 psi (3447 kPa) H/J
900 psi (6205 kPa) D/E
600 psi (4137 kPa) F/G
500 psi (3447 kPa) H/J
900 psi (6205 kPa) D/E
600 psi (4137 kPa) F/G
500 psi (3447 kPa) H/J
Max.
Temperature
406ºF (208ºC)
422ºF (217ºC)
800ºF (427ºC)
800ºF (427ºC)
Maximum Pressure/Temperature Chart ........................................................ 2
Installation Instructions ................................................................................... 3
Operating Instructions ..................................................................................... 3
Maintenance and Testing Instructions .......................................................... 4
500 Series Part Number Matrix ....................................................................... 4
Nameplate Information .................................................................................... 5
Amendment Register ....................................................................................... 6
IMPORTANT
Conbraco pressure relief valves are safety devices designed for the protection of lives and property. These
valves will provide years of service when properly installed and maintained. The information contained herein is
intended for use by qualified personnel to properly maintain these devices.
Serious property damage and injury or death may occur should a pressure relieving device fail to operate
correctly. Any installation, maintenance, adjustment, repair or testing should only be performed by experienced
personnel properly trained and qualified in accordance with applicable codes and standards.
When maintaining or repairing Conbraco pressure relief valves, use only original Conbraco parts to ensure safe
and reliable operation.
Contact your local Conbraco factory representative for the name of a factory authorized repair center near you.
Or visit us on the web at www.conbraco.com.
Maximum Pressure/Temperature Chart
Warning – Application must not exceed the pressure/temperature limitations below.
ES1196-1, IOM, 500 Series Rev. D
Loading...