Aphex EQF 500 User Manual

EQF 500

JENSEN TRANSFORMER BALANCED OUTPUT

3 BAND EQ WITH HPF AND LPF

500 SERIES MODULE

Owner’s Manual

®

SAFETY DECLARATIONS SAFETY DECLARATIONS

CAUTION: For continued protection against risk of fire, replace

only with the same type and rating of fuse.

ATTENTION: pour une protection continue contre les risques
d’incendie, ne remplacer qu’avec la même valeur et même type de
fusible.

WARNING: Do not place objects containing liquid on this unit as
it is not designed to protect against spillage. Do not expose this
unit to dripping or splashing of liquids as the unit is not designed
to protect against these occurances.

WARNING: This unit must be connected to a mains socket outlet
with a protective earthing connection.

WARNING: The EQF 500 has been tested and meets the FCC, CE
and European Union rules, regulations, and guidlines for use. Do
not attempt to modify or change the EQF 500, as this could void
the regulatory compliance, which would place you at risk of losing
your authority to operate the EQF 500.

WARNING: Do not place objects on top of this unit if they weigh
more than 10 pounds.

Page 2

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular instal­lation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

Page 3