Aperio A100-3090HC-1-121, A100-3090HC-1-626, A100-3090HC-2-121, A100-3090HC-2-626, A100-3090HP-1-121 Installation Instructions

...
June 2013 20 80-0180-347 Rev. A
NORMAL OPERATION HUB INDICATIONS
Adams Rite Manufacturing Co.
10027 S. 51st St. Suite 102
Phoenix, AZ 85044
Phone: 800-872-3267
Fax: 800-232-7329
NORMAL OPERATION LOCK INDICATIONS
Aperio™ eForce® A100
Narrow Stile Keyless Entry
Adams Rite Manufacturing Co. Phone: 800-872-3267 www.adamsrite.com
Owner’s Manual &
Installation Instructions
For Models
A100-3090H
June 2013 2 80-0180-347 Rev. A
Table of Contents
Table of Contents
Warning .............................................................................................. 3
Definitions ........................................................................................... 3
System Overview ............................................................................... 4
Operational Description ...................................................................... 5
Hub Location ...................................................................................... 6
Hub Wiring .......................................................................................... 7
Trim Installation Tools & Equipment .................................................. 8
Door Preparation ................................................................................ 9
Spindle Preparation .......................................................................... 10
Lock Series Configuration ................................................................ 11
Handing the eForce® ........................................................................ 13
Mortise Cylinder Installation ............................................................. 14
Rex/DPS Cable Installation .............................................................. 15
Mounting the eForce ........................................................................ 16
Battery Installation ............................................................................ 17
Limited Warranty .............................................................................. 18
Troubleshooting ............................................................................... 19
LED Indications ................................................................................ 20
June 2013 19 80-0180-347 Rev. A
TROUBLESHOOTING
The eForce A100 LED is normally off until a credential is presented and then LED will momentarily turn green if credentials are valid. A red LED will show if credentials are not valid.
Place known credential card in front of eForce®:
If the eForce® emits one short tone, but lock does not activate,
check Wiegand data lines for connectivity and proper connec­tion.
Green light comes on, but lever will not retract latch or deadbolt:
Check the eForce® body connection with lock/latch mechanism.  Check the spindle length (see installation instructions). Check for proper door preparation (refer to door templates).
No lights come on and Operator stays unlocked (unsecured): Ensure credential card matches reader type (iCLASS or PROX) if
they do not match, the card will not trigger the eForce reader.
Check the eForce® body connection.  Check battery level, replace if necessary. Check that the Battery cover is installed and secured.
Credentials not activating lock:
Trigger access control system to unlock the device. If this unlocks the lock:
Ensure that credentials are in system database.
Refer to additional EAC documentation.
June 2013 18 80-0180-347 Rev. A
LIMITED WARRANTY
Adams Rite Manufacturing Co. (hereinafter ADAMS RITE) manufactures its products in a manner to be free of defects. Should any defect of manufacture (in material or workmanship) occur in its products, ADAMS RITE, upon prompt notification and proof to its satisfaction that the product was defective in manufacture for the use intended by ADAMS RITE, will at its option, ex­change the product, repair the defect or refund the price charged by ADAMS RITE, FOB factory based on the following schedule:
All mechanical products for five (5) years from the date of manufacture; All electrical products (including EL and ED exit devices) for three (3)
years from the date of manufacture; The RITE Door® for five (5) years from the date of manufacture; UltraLine Electric Strikes for five (5) years from the date of manufacture.
Limitations and exclusions: This is a limited warranty and is in lieu of all other warranties including the implied warranties of merchantability and fit­ness for use) and under no circumstances shall ADAMS RITE be liable for any incidental or consequential damages or losses.
This warranty covers products as outlined above manufactured from May 1, 2003 forward.
This warranty does not cover damages from such causes as abuse, accident, neglect, fire or freight damage.
WARRANTY CONDITIONS
The selling dealer from who this exit device was purchased is responsible for advising the purchaser of the period of no charge warranty exchange, repair or refund. Replacement parts under the terms of the warranty must be fur­nished by the Adams Rite dealer or agency.
FACTORY ASSISTANCE
If the purchaser is unable to locate a service agency, or if the purchaser does not receive satisfaction from the source of which the exit device was pur­chased, or from local dealer, write or contact Adams Rite at the following ad­dress:
Adams Rite Manufacturing Co. 10027 S. 51st St. Suite 102 Phoenix, AZ 85044 Phone: 800-872-3267 Fax: 800-232-7329 www.adamsrite.com
June 2013 3 80-0180-347 Rev. A
WARNING
FCC Statement
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Operation with non-approved equipment is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the
equipment without the approval of manufacturer could void the user’s authority to oper-
ate this equipment.
IC Statement
This class [B] digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
DEFINITIONS
Aperio™ Aperio is a wireless lock technology for use with an access control sys-
tem. Aperio is developed by ASSA ABLOY, the global leader in door opening solutions.
Electronic Access Control (EAC) System – The EAC system provides the access
decision to the hub where access to the lock is either granted or denied.
Wiegand – Communication protocol utilized between the Aperio
®
hub and access
control system, which consists of two data lines, WG0, WG1.
PROX – Class of contactless card credentials that operate on 125kHz.
iCLASS – Class of contactless card credentials that operate on 13.56MHz.
Secured State – State of eForce
®
: turning lever does not retract latching hard-
ware.
Unsecured State – State of eForce
®
: turning lever retracts the latching hardware.
Loading...
+ 7 hidden pages