Apart OVO3T User Manual [ru]

MANUAL

OVO3T

[e-mail]

1

Introduction

Please read this manual before using the product in order to give you the needed
product and installation instruction to assure a seamless installation and non
compromised overall sound quality.

Thanks for purchasing our APart OVO3T speaker. Budget and quality sound united:
welcome the OVO-speakers. This series of cabinet speakers fit into any décor or
interior style. The OVO3T can be used in both 100V- and 16Ohm-systems thanks
to an easily accessible selection switch. The OVO3T uses a new bracket system
that allows a wide range of positioning. In case you want to place your OVO
on a flat surface, you can use the delivered pad. The sturdy ABS plastic housing
guarantees years of trouble free musical enjoyment. Affordable, but by no means a
compromise on sound quality – Typically APart!

Safety precaution

• Keep this manual for future reference.

• Take care of your speaker wires, they should be free of damage. Damaged

speaker wires might result in poor sound quality and can damage amplifiers.

• Only use accessories specified by the manufacturer

• Make sure the ceiling or wall construction can support the speakers weight.

• Use sufficient amount of speakers to avoid death-spots.

• No main power shall be connected to the loudspeakers, doing so will damage

the speaker.

• This apparatus should only be serviced by qualified personnel. If not warranty
might be void.

• The speaker grill is fixed, removing it can damage it.

• Use cable of the right gauge, certainly for long runs.

• Use cables with clear color indication and maintain polarity throughout the

whole system.

2

WWW.APART-AUDIO.COM

• Avoid loud feedback from microphones, this can damage your speaker.

• Please check the units condition after unpacking. If the outside of the carton

box has been damaged, inform your shipper immediately.

• Take notice that the speaker must be protected from direct rain.

Features and benets

• Inconspicuous and elegant design

• Remarkable quality sound and extremely affordable.

• 3 inch coated paper woofer and 1inch silk dome tweeter.

• 40 Watts program power at 16 Ohm.

• 6 – 3 – 1.5 Watts easily selectable 100 V transformer.

• ABS plastic housing

• Useable for both 100 V and low impedance systems.

• Mounting bracket that allows tilting and turning.

• Free stand pad for usage on flat surfaces like desks.

• Quick fit cable clamps for quick and easy mounting.

• Indoor use only

• Can be painted in any RAL color from a minimum

of 12pieces. (ref.: PAINTCAB6)

[e-mail]

3

Connecting the speaker

Use the correct polarity when daisy chaining speakers! When a mistake occurs
in your daisy chain, it can severely impact speaker performance as there will be
audio-cancellation.
The daisy chain options are endless and the setup will depend on the capabilities of
your amplifier. Make sure when daisy chaining speakers that the total impedance is
not lower than the lowest specified impedance of your amplifier. Not following this
rule might result in distorted sound and might even damage your amplifier.

Series wiring speaker diagram:

Total resistance = R1 + R2 + R3 + R4 + ...

Parallel wiring speaker diagram:

(-)

(+)

Total resistance =

1/R1 + 1/R2 + 1/R3 + 1/R4 + ...

R1 = Resistance of speaker 1
R2 = Resistance of speaker 2
R3 = Resistance of speaker 3
R4 = Resistance of speaker 4

(+) (-)

1

4

WWW.APART-AUDIO.COM

100V technology

20W 20W 10W 5W 5W 5W 2.5W 2.5W

70 Watt

120 Watt

Amplier

Amplifier power must be equal higher than total power of all speakers

≥ + + + + + + +

Specications

Woofer 3 inch coated paper
Tweeter 1 inch silk dome tweeter
Shape cabinet
100 Volt power taps 6W, 3W, 1.5W
Music power RMS 40W / 16 Ohm
Frequency response 90 Hz to 20 kHz
SPL 1W / 1m 86dB
SPL 1m / max rated power 102dB
Dispersion at 1kHz, 4kHz, 8kHz 180°, 120°, 80°
Color white or black
Cabinet construction ABS with bass reflex
Grille material Steel
IP class 60
Fixing type mounting bracket or table stand
Height (mm) 160mm
Width (mm) 110mm
Depth (mm) 117mm
Net weight (pair) 2,1Kg
Gross weight (pair) 2,3Kg

[e-mail]

5

Polar diagram 1000 Hz

Polar diagram 4000 Hz

Polar diagram 8000 Hz

6

WWW.APART-AUDIO.COM

Technical drawing with measurements

Warranty info

APart-Audio warrants this product to be free of defects in material and workmanship
for a period of one year for parts and for a period of one year for labor from the
date of original end-user purchase. This warranty is valid only for the original end­user and cannot be transferred.

During the warranty period APart-Audio or one of its authorized service partners
shall either repair or replace any product, free of charge, that proves to be
defective on inspection by APart-Audio or its authorized service representative.

This warranty does not include, damages or product faults due to abuse, misuse or
faulty installation.

[e-mail]

7

ANY SUGGESTION?

Company names, product names, and names of formats etc. are the trademarks or registered

© 2011 APart-Audio specifications subject to change without notice.

8

WWW.APART-AUDIO.COM

They are well appreciated and eventually rewarded!

Send your ideas or suggestions to

[e-mail]

trademarks of their respective owners.

developed by

Industriepark Brechtsebaan 8 bus 1

Audioprof nv

2900 Schoten

Belgium