APAC SCM 560506 users Mnual

Manual

Commodity name: Remote Control Mail Box Alarm
Model: 560506
Picture: the sketch map of main parts
Installation Instruction:

1. Transmitter: Use the crossed screwdriver to open the battery cover, set in a

12V23A battery according to the right electrode, and lid the cover.

2. Receiver: Open the battery cover and set in two 2AA batteries according to the
right electrode.

3. Placed the transmitter, placed the receiver on where don’t have icebox, TV set, magnet and

metal object.

Function operation

1. Placed the transmitter on a vertical plane after set a battery, the transmitter enter
into waiting state, the transmitter will send out a radio wave signal right away
when the transmitter incline and make a angle less than 45 degree with the
horizontal.

2. The transmitter stop sending out signal and enter to waiting state when it return to
initialization.

3. The music will stop automatically after it lasting 8 seconds after the receiver
finish to receiving signal; the indicator light glitter quickly according to fixed time
interval, and it will not stop glittering until you press the reset button. After that
the indicator light enter into waiting state.

4. You can adjust the volume by the button that is on the right side of receiver.

5. The indicator light on the receiver will glitter twice quickly according to a fixed
time interval if the battery has not enough voltage after use a period of time. And
if the transmitter’s batteries have not enough voltage, the indicator light on the
transmitter will glitter thrice quickly according to a fixed time interval. You should
change a new battery.

Caution:

Change or modifications to this unit not expressly approved by the party responsible
for compliance will void the user’s authority to operate the equipment. Any change to
the equipment will void FCC grant.

Note:

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

-----Reorient or relocate the receiving antenna.

-----Increase the separation between the equipment and receiver.

-----Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-----Consult the dealer or an experienced radio/TV technician for help.

Modifications not authorized by the manufacturer may void users authority to operate
this device.