Anybus PoE Injector, AWB4006-B Startup Guide

Anybus®PoE Injector

12–57 VDC

STARTUP GUIDE

SP2385 EN 1.1 ENGLISH

Important User Information

Liability

Every care has been taken in the preparation of this document. Please inform HMS Industrial Networks AB
of any inaccuracies or omissions. The data and illustrations found in this document are not binding. We,
HMS Industrial Networks AB, reserve the right to modify our products in line with our policy of continuous
product development. The information in this document is subject to change without notice and should not
be considered as a commitment by HMS Industrial Networks AB. HMS Industrial Networks AB assumes no
responsibility for any errors that may appear in this document.

There are many applications of this product. Those responsible for the use of this device must ensure that
all the necessary steps have been taken to verify that the applications meet all performance and safety
requirements including any applicable laws, regulations, codes, and standards.

HMS Industrial Networks AB will under no circumstances assume liability or responsibility for any problems
that may arise as a result from the use of undocumented features, timing, or functional side effects found
outside the documented scope of this product. The effects caused by any direct or indirect use of such
aspects of the product are undefined, and may include e.g. compatibility issues and stability issues.

The examples and illustrations in this document are included solely for illustrative purposes. Because of the
many variables and requirements associated with any particular implementation, HMS Industrial Networks
AB cannot assume responsibility for actual use based on these examples and illustrations.

Intellectual Property Rights

HMS Industrial Networks AB has intellectual property rights relating to technology embodied in the product
described in this document. These intellectual property rights may include patents and pending patent
applications in the USA and other countries.

Anybus®PoE Injector Startup Guide SP2385 EN 1.1

About This Document 3 (12)

1 About This Document

This document describes how to install Anybus PoE Injector 12–57 VDC.

For additional documentation and technical support regarding this product,
please visit www.anybus.com/support.

Document Conventions

The following formatting conventions are used in this document to indicate safety
information and other content of specific importance:

WARNING

This instruction must be followed to avoid a risk of death or serious injury.

Caution

This instruction must be followed to avoid a risk of personal injury.

This instruction must be followed to avoid a risk of reduced functionality
and/or damage to the equipment, or to avoid a network security risk.

This is additional information which may facilitate installation and/or
operation.

Anybus®PoE Injector Startup Guide SP2385 EN 1.1

Description 4 (12)

2 Description

Anybus PoE Injector 12–57 VDC is a dual port 802.3af/at compliant Power over
Ethernet injector with Midspan Intelligent Detection.

The PoE injector will not turn on power until it detects a valid PoE signature from
the devices attached downstream on the Ethernet cable. This protects non­compliant equipment against damage.

Anybus PoE Injector 12–57 VDC will not function with equipment that is not fully
compliant with the IEEE 802.3af/at PoE standards.

The unit requires an external 12–57 VDC power supply (not included).

Fig. 1 Dimensions

Anybus®PoE Injector Startup Guide SP2385 EN 1.1