Anvil America WMA7500 Installation Manual

INSTRUCTION MANUAL

WRAPPING MACHINE (20”)

WMA7500

INSTALLATION, OPERATION AND CARE OF

WMA7500 WPAPPING MACHINE

_____________________________________________________________________________________________________

INSTALLATION

UNPACKING: Unpack the product and check for any damage incurred during transit.
This should be reported to the responsible carrier, railway or postal authority, and a
request for a damage report should be made.

THESE INSTRUCTIONS MUST BE FOLLOWED FOR US TO
GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM FOR
PROTECTING AGAINST LOSS FROM CONCEALED
DAMAGE. THE FORM FOR FILING SUCH A CLAIM WILL
BE PROVIDED BY THE CARRIER.

GENERAL INSTALLATION AND OPERATING
INSTRUCTIONS:

1. Position wraping machine in a suitable position.

2. Plug unit into wall socket and switch on via the non-illuminated rocker switch.

3. Select desired width of shrink-wrap plastic and place as indicated in Diagram A
on the rear rollers.

4. Feed shrink-wrap plastic through the wrapping plate also as indicated in Diagram A.

5. Cover item to be wrapped as indicated in Diagram B.

6. Cut plastic on Teflon heating bar as indicated in Diagram C and place completed

IT IS ESSENTIAL TO MAKE SURE THAT THE INCOMING
VOLTAGE IS THE SAME AS THE RATED VOLTAGE OF THE
UNIT AS FOUND ON THE SERIAL PLATE. THE SERIAL
PLATE IS LOCATED AT THE REAR OF THE UNIT
ADJACENT TO THE INCOMING CABLE ENTRY.

wrapped item onto heating plate for a few seconds for final sealing.