Anvil America RDE7136R00 Installation Manual

Page 1

L2

L1

120V 60Hz

GND

WIRING DIAGRAM

MODEL : REFRIDGERATED COUNTER TOP DISPLAY CABINET 120V 60Hz

MODEL CODE : RDE7136R00

RDE7148R00

RDE7160R00

M1

M2

S1

L1

L2

TR2

T2

M3 M4

M5

SR

120V

12V

FA

2 3 7

R2

4

TR1

1

R1

5 6

JC612

INSTALLATION, OPERATION AND CARE OF :

COUNTERTOP REFRIGERATED DISPLAY CABINETS
MODELS RDE7136R00, RDE7148R00, RDE7160R00

UNPACKING: Unpack the product and check for any damage incurred during
transit. This should be reported to the responsible carrier, railway or postal
authority, and a request for a damage report should be made

Page 6

THESE INSTRUCTIONS MUST BE FOLLOWED FOR US
TO GUARANTEE OUR FULL SUPPORT OF YOUR CLAIM
FOR PROTECTING AGAINST LOSS FROM CONCEALED

!



DAMAGE. THE FORM FOR FILING SUCH A CLAIM WILL
BE PROVIDED BY THE CARRIER.

GENERAL INSTALLATION AND OPERATION INSTRUCTIONS:

The ANVIL Refrigerated Countertop Display cabinets are designed for illuminated
display of food products at temperatures between 36F° - 46F°. The cooling system
ensures that the products placed inside can be stored at the correct
temperature.

1. The unit can be either placed on a suitable work surface or it can be tted

into a countertop. Remember to install the unit in the most convenient
location for care of cleaning, maintenance and point of sale display.

2. If the unit is to be tted into a countertop please ensure that the cut out

details are observed. It is essential that good ventilation is
maintained by ensuring that the cut out details are STRICTLY adhered to.

3. IF THE UNIT HAS BEEN TRANSPORTED IN A NON-VERTICAL POSITION
ALLOW AT LEAST 1 HOUR FOR THE FOR THE OIL TO FLOW BACK
INTO THE COMPRESS0R AFTER FINAL INSTALLTION BEFORE
SWITCHING ON

4. Assemble the shelving system and rear doors.

5. Remove all the protective lm from exposed stainless steel parts and sur

faces.

6. The unit is designed for food display. Clean carefully before using by

following the specic cleaning instructions detailed later in this manual.

7. Plug the unit into a suitable power source as detailed later in this manual.

8. The unit is provided with an illuminated main switch. Operation of this switch
turns on the unit and allows set up of the temperature.

9. Set the desired operating temperature on the digital controller. Specic

setting instructions are detailed later in this manual.