Antunes CTX-200 Installation Manual
of your
®
A.J. ANTUNES & CO.
TOLL FREE: 1-877-392-7854
www.ajantunes.com
TABLE OF CONTENTS
This manual is for the exclusive use of licensees and employees of McDonald’s Systems, Inc..
© McDonald’s Corporation All Rights Reserved
The Antunes Food Service Equipment Division of A.J. Antunes & Co. provides the following limited warranty to the original purchaser of all McDonald’s Equipment
All components are warranted against defects in the material and workmanship for a period of two (2) years from date of original installation, not to exceed 30 months
from date of shipment from our factory.
Authorized Service Agent to replace the part, plus travel expenses up to 50 miles/80 km, 1 hour each way (100 miles/160 km, 2 hours round trip).
Antunes Food Service reserves the right to make changes in design or add improvements on any products. The right is always reserved to modify Equipment
This warranty is exclusive and is in lieu of all other warranties, expressed or implied, including any implied warranty of merchantability or fitness for a particular pur-
for special consequential or incidental damages for the breach or delay in the performance of this warranty.
WARRANTY EXCLUSIONS
• The cost of Installation.
• Equipment that has been damaged due to shipment. Purchaser should
• Alteration, misuse, abuse.
• Improper storage or handling.
• Improper maintenance.
• Failure to follow proper Installation instructions, including electrical connec-
tion.
• Improper or unauthorized repairs.
• Scheduled Maintenance procedures as outlined in your MRC Card.
• Consumables such as Grill Covers (Release Sheets), gaskets, Conveyor Belt
Wraps, O-Rings, and light bulbs.
• Overtime or Holiday charges.
• Mileage over 50 miles/80 km (100 miles/160 km round-trip), or travel time
over two (2) hours.
• Freight, foreign, excise, municipal or other sales or use taxes.
• Consequential damages such as loss of profit, loss of time, the cost of repair-
damage of any kind.
......................................................................
2
Warranty Information
.................................................
2
Specifications
3
..........
...................................................................
.....................................................................
Assembling the Unit
6
...............................................
Adjusting Toasting Quality
Toasting Clubs
...........................................................
Viewing the Program Mode Settings
8
8
............................
..............................................................
.............................................
2
Troubleshooting
...................................................
Wiring Diagram
9
CLUB
C
T
L
US
CM
N
This manual is produced for the Club Toaster.
The Club Toaster is designed to toast the club portion
of buns using an inclined platen conveyor. The Club
Toaster uses contact toasting on both sides to provide
an evenly toasted product.
This manual provides the safety, installation and oper-
ating procedures for the Club Toaster. We recommend
that this manual be read prior to installing and operat-
The Club Toaster is manufactured from the finest mate-
quality standards. This unit has been tested at the fac-
tory to ensure dependable trouble-free operation.
OWNER INFORMATION
operation of your unit, contact your Authorized Service
Agency.
calling your Authorized Service Agency for assistance.
The serial number is on the specification plate located
on the rear of the unit.
your manual and fill in the information below:
Authorized Service Agency
Address:
Authorized Service Agency has been factory trained
and has a complete supply of parts for this toaster.
You may also contact the factory at 1-877-392-7854
To locate your nearest International Authorized Service
Agency: log onto the McDonald’s web site: www.
Warranty Information
diately and file a damage claim with them. Save all
claims are the responsibility of the purchaser and are
The warranty
does not
extend to:
• Damages caused in shipment or damage as
result of improper use.
• Installation of electrical service.
• Normal maintenance as outlined in this manual.
• Malfunction resulting from improper maintenance.
• Damage caused by abuse or careless handling.
• Damage from moisture into electrical
components
• Damage from tampering with, removal of, or
changing any preset control or safety device.
SPECIFICATIONS
All electrical connections must be in accordance with
WARNING
does not fit the outlet, have a proper outlet installed
doubt as to whether the appliance is properly
grounded.
(737 mm)
29”
(463 mm)
18-1/4”
(635 mm)
25”
(235 mm)
9.25”
Mfg. No
Voltage
208 V
60
240 V
4.3 kW
60
208 V
60
240 C
4.3 kW
60
Throughout this manual, you will find the following safety words and symbols that signify important safety
IMPORTANT SAFETY INFORMATION
• Read all instructions before using equipment.
• For your safety, the equipment is furnished with
a properly grounded cord connector. Do not
attempt to defeat the grounded connector.
• Install or locate the equipment only for its intend-
ed use as described in this manual. Do not use
corrosive chemicals in this equipment.
• Do not operate this equipment if it has a dam-
aged cord or plug, if it is not working properly, or
• This equipment should be serviced by qualified
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
• Do NOT clean this appliance with a water jet.
The following warnings and cautions appear throughout
this manual and should be carefully observed.
• Turn the unit off, wait for the cool-down procedure
to complete its cycle (45 minutes), and discon-
vice or maintenance on the unit.
turn off all power to the unit. When the unit
will flash to indicate that the power cord is
• The procedures in this chapter may include
the use of chemical products. These chemical
ters followed by the abbreviated
• The equipment should be grounded according to
electrical shock. It requires a grounded recep-
tacle with separate electrical lines, protected by
fuses or circuit breaker of the proper rating.
• Bread may burn. Therefore toasters must not be
walls and materials. Failure to maintain safe
operating distances may cause discoloration or
combustion.
This equipotentiality symbol shows
external functional grounding connection.
WARNING
the equipment, severe bodily injury or even death.
WARNING
observe may result in damage to the equipment
and/or severe bodily injury or death.
tant to the proper operation of the equipment.
equipment.
WARNING
WARNING
To avoid possible personal injury and/or dam-
age to the unit, all inspections, tests, and repair
of electrical equipment should be performed by
before
any internal servicing, except when electrical
tests are required. Use extreme care during elec-
trical circuit tests. Live circuits will be exposed.
When placing the toaster into service, pay attention to
the following guidelines.
• Make sure power to the unit is off and the toaster
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
specification plate for the proper voltage.
WARNING
electrical codes to prevent the possibility of electri-
cal shock. It requires a grounded receptacle with
separate electrical lines, protected by fuses or cir-
cuit breaker of the proper rating.
doubt as to whether the appliance is properly
grounded.
walls and materials. Failure to maintain safe oper-
ating distances may cause discoloration or com-
All electrical connections must be in accordance
with local electrical codes and any other appli-
1. Remove the CTX-200 (Figure 1) and all packing
the accessories box and remove the accessories
• 1 Bun Feeder (Figures 1 and 2)
2. Remove all packing materials and protective
coverings from the unit and parts.
5. Wash the accessories in hot, soapy water, rinse
these parts with a clean cloth dampened with
tact A.J. Antunes Technical Service IMMEDIATELY
at 1-877-392-7854 (North America only), or 630-784-
INSTALLATION
to sit side by side. The UTX-200 can be placed on
the right or left side of the CTX-200 by putting the
side that is NOT flush against the CTX-200.
accessory becomes bent or damaged, it may not
attach to the unit correctly, which may affect normal
operation.
CLUB
6
Assembling the Unit
Assemble the unit as shown in Figures 1 and 2.
INSTALLATION (continued)
to the right or the left side
of the toaster depending on
and CT toasters)
Loading...