Anthro Fit Utility Unit Assembly Instructions
R
01–Work Surface
.................................
Qty. 1
.......................
(see below)
24" Wide Work Surface
(FY2429zz/xx3)
...........
30" Wide Work Surface
(FY3029zz/xx3)
...........
36" Wide Work Surface
(FY3629zz/xx3)
...........
02– Fit Small Support Y
....................
Qty. 1
...................
225-2015-00
03– 22.875" Vertical Legs
.................
Qty. 4
...................
04– 21" Base Tubes
..............................
Qty. 2
..................
05– Cross Tubes
................................
Qty. 2
.......................
(see below)
24" Wide Base Tube
(FY2429zz/xx3)
...................
30" Wide Base Tube
(FY3029zz/xx3)
...................
36" Wide Base Tube
(FY3629zz/xx3)
...................
06– Insert Screws
.................................
Qty. 4
...................
325-5052-00
07– 2" Large End Caps
.......................
Qty. 4
...................
08– 3" Locking Casters
......................
Qty. 2
...................
09– Caster Inserts
...............................
Qty. 4
...................
525-5032-00
5
/
"-18 Fit
............................
...................
.........................
..
...........
...................
/
4
.........................
...................
....................
...................
............................
...................
....................................
.......................
24" Wide Back Trough
..............
30" Wide Back Trough
..............
36" Wide Back Trough
..............
.............................
...................
/
4
....
...................
All Screw quantities listed here are the minimum needed
Anthro
10450 SW Manhasset Drive Tualatin, Oregon 97062 anthro.com
Attaching the Base Assembly to the Legs
Align the Base Assembly on the Legs as shown. Secure
the Base Assembly to the Legs by inserting a Bolt through
Your assembly is complete.
that your shipment is complete.
you purchased and are planning to
/
...........
/
.....
.....
/
Assembly Instructions
Anthro
®
10450 SW Manhasset Drive Tualatin, Oregon 97062
Attaching Shelf Supports to the Shelf
will place your Shelf 29" from the Floor using the standard
Attaching the Legs to the Work Surface
Attach a Leg to the rear of the Shelf using two Support
the screws a little loose. Repeat for the other three legs.
Assembling the Base Tube
with one Insert Screw per Caster Insert.
Attaching the Back Trough to the Shelf Supports
the installed Small Supports
Align the two threaded holes on each end of the Back
the Back Trough, but don’t tighten all the way.
Align the holes in the bottom fl ange of the Back Trough with
the pre-drilled holes on the Work Surface. Attach the Back
/
4
/
/
4
: Make certain to install
Assembly Instructions
Attaching the Cross Tubes to the Base Tubes
Attach a Cross Tube to a Base Tube by inserting a
through a Tube Washer, then insert the Bolt through
the
/
Loading...