Anthony Gallo Nucleus Micro Ti User Manual [en, es]

CChhaattsswwoorrtthh,, CCAA 9911331111 UUSSAA

Micro Ti

ANTHONY GALLO

ACOUSTICS

Owner’s Manual

Fill Out Warranty Information on back, detach and

return to us for your five year product warranty.

AAnntthhoonnyy GGaalllloo AAccoouussttiiccss

2200884411 PPrraaiirriiee SSttrreeeett

ANTHONY GALLO

ACOUSTICS

Stamp

Here

Place

To find a dealer near you, please visit our web site at: www.anthonygalloacoustics.com

1 USA

Anthony Gallo

Acoustics, 20841 Prairie Street, Chatsworth, CA
Phone [phone] • Fax [phone]

9131

WWAARRNNIINNGG

c

TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO WATER OR
MOISTURE. ALSO, DO NOT USE THIS UNIT’S PLUG WITH AN EXTENSION CORD
RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED.
REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS
INSIDE. REFER SERVICING

TO MANUFACTURER.

m

CCAAUUTTIIOONN

c

CCAAUUTTIIOONN:

UNPLUGGED FROM WALL SOCKET. TO FULLY DISENGAGE THE POWER TO THE UNIT,
PLEASE DISCONNECT THE POWER CORD FROM THE AC OUTLET. DO NOT REMOVE COVER
(OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO
MANUFACTURER.

c

:

TO REDUCE THE RISK OF ELECTRIC SHOCK, MAKE SURE POWER CORD IS

This symbol warns user that uninsulated voltage within the unit may have sufficient magnitude
to cause electric shockl. Therefor, it is dangerous to make any kind of contact with any part inside this unit.

This symbol alerts the userthat important literature concerning the operation and maintenance of this unit has
been included. Therefore, it should be read carefully in order to avoid any problems.

m

m

Excellent Very Good Good Fair Poor

Magazine Web Dealer Other

Name: Micro Ti Serial #

Address:

City: State: Zip:

Telephone: Email:

Where did you first hear about the Micro Ti ?

Very Somewhat Not At All

How influential was your dealer in your decision to purchase the Micro Ti ?

Stereo Home Theatre

Appearance

Build Quality

Size

What type of system did you purchase?

What’s the dealers name and address you purchased this Product from ?

What other Speakers did you listen to before choosing the Micro Ti ?

Ease of Set Up

Sound Quality

Mounting Options

Match my decor

Owners Manual

Introduction

Welcome to Anthony Gallo Acoustics!

Thank you for choosing us! The Micro Ti was designed along the lines of our original Nucleus Micro
speakers. Two distinct advantages of this model are the high frequency capabilities of our new paper­damped Titanium drivers along with an improved stainless steel perforated grill. The spherical enclosure
is ideally suited to perform in locations that would hinder most conventional designs and their refined and
natural sound will complement music, home theater, and multi-room systems.

Please take a moment to review the information in this manual so you can properly install your new
speakers. If you have any questions about this or any other Anthony Gallo Acoustics' product, please call
us at [phone] or send us an e-mail at: [e-mail] As one of our valued customers
your feedback is always welcome.

We think you'll be delighted at how easy it is to connect your Micro Ti Speakers, and how amazing the
sound quality will be. So read on, and let's get you started.

About your Nucleus Speaker "Break In"

20

Your new Micro Ti speakers will need a little time to develop their full sound potential. You'll hear a marked
increase in bass and treble response after about 50 hours of use.

Speaker Placement Tips

The Micro Ti isn't very placement sensitive, but to achieve maximum bass it should be situated near a wall
or large surface. We highly recommend using one of our various brackets or stands to successfully
integrate them into your system.

You can place them at any reasonable height, just make sure the speakers are aimed directly into the
prime listening location.

-type television without

Since the Micro

fecting its picture.

af

i is magnetically shielded it may be placed right next to a CR

T

T

1

Getting Connected

PPrroocceeddiimmiieennttoo ddee sseerrvviicciioo ppaarraa ttooddooss llooss pprroodduuccttooss ddee AAnntthhoonnyy GGaalllloo AAccoouussttiiccss ((AAGGAA)

)

Hooking Up Your Micro Ti Speakers

PLEASE NOTE: Turn your sound system off before proceeding with the installation of your new speakers.
The Micro Ti's speaker connectors accept bare wire ends, small spades or banana plugs (When using
bananas make sure the wire nuts are tightened completely. Failure to do so can exert excess stress on
the shafts causing breakage).

As you hook-up the wires make sure the (+& -) speaker connections on your receiver/amplifier, satellites
and subwoofer are properly oriented. In other words, confirm that ALL of your speaker connections are
positive-to-positive (red-to-red) and negative-to-negative (black-to-black). Even one flip-flop may result in
lower bass output or compromised stereo imaging.

Standard Stereo System Set-Up

These speakers must be used in conjunction with bass filtering, i.e. (small enclosure) setting of a surround
sound receiver
high pass filter. This is required as with other small speakers to block low bass that can possibly do
damage to the speakers. See the instructions below for use with subwoofers. (For the best results we offer
our own wire in 100’ rolls of 18 gauge solid-core, oxygen-free copper wire as an accessory)

. Another option would be to use them in conjunction with a subwoofer that incorporates a

Stereo System Set-Up with a Gallo MPC-1 Passive Subwoofer

QQuuéé hhaacceerr ssii uunn pprroodduuccttoo AAGGAAnneecceessiittaa rreeppaarraacciióónn:

1. Póngase en contacto con el vendedor autorizado de productos AGA al cual le haya comprado
originalmente el producto. Puede resultar conveniente tener a mano la factura de compra original para
determinar la validez de la garantía. Averigüe cómo puede ayudarle el vendedor si necesita solucionar
algún problema relacionado con el producto o si necesita reparación u otro servicio.

2. Si es poco práctico o imposible comunicarse con el vendedor original, consulte la sección de búsqueda
de vendedores autorizados Dealer Locator en www.roundsound.com. Ubique al vendedor autorizado más
cercano y contáctelo para hacer los arreglos necesarios a efectos de obtener el servicio.

3. Si lo prefiere, puede enviar el producto al Servicio de fábrica de
cuidadosamente en la caja original y envíelo al centro de servicio. Puede ser necesario enviar una copia
de la factura para determinar si la garantía sigue siendo válida. Llame al centro de servicio al +1 (800)
459-4183 para obtener un número de autorización de devolución (Return
describa el problema e informe la dirección a la que deberá devolverse el producto y un número de
teléfono al que se pueda llamar en horas del día. Se sugiere que elija un transportista que ofrezca
servicios de seguimiento de los envíos (parcel tracking) y seguro.

El privilegio de la garantía se pierde comprando productos AGA a través de minoristas no autorizados,
canales de ventas por Internet y por catálogo.

:

AGA. Embale el producto

Authorization Number, RA#),

Run the cables from your receiver/amplifiers Left and Right speaker connectors to the "In" connectors of
the MPC-1’s Crossover Module….inserting the red bananas at the MPC-1 end. Next, run the speaker
wires from Left & Right "High Pass" jacks of the MPC-1’s Module to the Micro Ti’s on the Left & Right (the
black bananas go to the MPC-1). Run the supplied Left & Right jumper cables (The ones with 1/4-inch
male phone jacks) from the MPC-1 Module's “Subwoofer Out” jacks to the corresponding input jacks on
the MPS-B subwoofer bottom. (For more in-depth info please see the MPC-1 owners’

manual)

2 19