Ansell Lighting ALHL/PIR/WH, ALHL/PIR/BL, ALHL/BL, ALHL/WH, ALHL/PC/WH Installation Instructions

Description – Latina Polycarbonate Half Lantern

Disposal of Electronic Equipment WEEE Directive 2002/96/EC

2002/9

5

/EC compliant

.

® Installation Instructions

Luminaire Code(s) –

ALHL/ & ALHL/PIR/

General Installation Instructions
These instructions should be read carefully prior to any installation and retained after completion for further
reference and maintenance. Please give these instructions to the building owner/occupier after installation.

Important Safety

1. Before installation, maintenance or lamp replacement, ensure that the mains supply to the luminaire is switched off and the circuit supply fuses are

removed or the circuit breaker is turned off.

2. It is recommended that only a qualified electrical contractor carries out the installation of this luminaire and that the luminaire is installed in

compliance with the current edition of the IEE Wiring Regulations.

3. The person carrying out the installation is to check and verify that the total load on the circuit, including that of this luminaire does not exceed the

rating of the circuit cable, fuse or circuit breaker.

4. Where a luminaire incorporates discharge control gear (inductive load), the circuit capacity and ratings require careful sizing to avoid nuisance

tripping of the protective device used in the installation.

5. Where applicable, careful consideration should be taken during installation to ensure that all fixings and/or suspensions are of a suitable size for the

luminaire being installed.

Ratings

1. All luminaires are manufactured & tested in compliance with the requirement contained within BS EN 60598 and are CE marked.

2. All luminaires that are of Class 1 construction and that are marked accordingly, MUST be earthed.

3. All luminaires are designed to operate at 230Volts AC -6%/+10% = 216Volts to 252Volts. Do not operate outside these voltages.

4. All luminaires are only suitable for applications within their rated Ingress Protection limits as stated.

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Installation

• Remove the stainless steel screw on the base of the luminaire.

• Lift and remove the whole front cover.

• Remove the four self taping screws on the diffuser.

• Select a suitable cable entry point.

• Position and fix the base to a suitable solid surface.

• Terminate the supply cable into the terminal block mounted in the base, ensuring correct polarity is observed and

an earth provision.

• Supply & fit lamp into the lampholder. (Ansell recommend the use of recognised branded lamps in all luminaires.) 42W MAX

• Re-fit the front cover and diffuser.

• Replace the stainless steel screw at the base of the luminaire

• Restore power supply, switch on and test for satisfactory operation.

• Note - It is the responsibility of the Installer to ensure the cable connection meets the requirements of IP65. A compression gland

rated to IP65 or greater is recommended, however where IP65 is not needed a grommet is provided which can be protected further
by the addition of a suitable silicon sealant.

PIR Version /PIR

the luminaire has

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Maintenance:

1. Where applicable, it is important to ensure failed lamps are replaced immediately in order to prevent damage to the control gear.

2. Always replace lamps with the same lamp type and wattage as supplied. If you are in doubt, please contact your equipment supplier or

Ansell Lighting for further advice.

Blue / Black

Brown / Red

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

www.anselluk.com

IP65

This product falls within the scope of the Waste Electrical & Electronic Equipment Directive
(WEEE), which means the product should not be disposed of as normal household waste.
Ensure that this luminaire and lamp is disposed of in accordance with the WEEE Directive.
Contact a local Council Waste Dept. Local Amenity Site, or the Environment Agency for
further information. RoHS - All components and materials used in this product are RoHS

Issue Date: td 20120913