p
Description – Jasper 7.5W 3000K LED Pendant
Installation Instructions
General Installation Instructions
These instructions should be read carefully prior to any installation and retained after completion for further
reference and maintenance. Please give these instructions to the building owner/occupier after installation.
- Important Safety
1. Before installation, maintenance or lamp replacement, ensure that the mains supply to the luminaire is switched
off and the circuit supply fuses are removed or the circuit breaker is turned off.
2. It is recommended that only a qualified electrical contractor carries out the installation of this luminaire and that
the luminaire is installed in compliance with the current edition of the IEE Wiring Regulations.
3. The person carrying out the installation is to check and verify that the total load on the circuit, including that of this
luminaire does not exceed the rating of the circuit cable, fuse or circuit breaker.
4. Where a luminaire incorporates discharge control gear (inductive load), the circuit capacity and ratings require
careful sizing to avoid nuisance tripping of the protective device used in the installation.
5. Where applicable, careful consideration should be taken during installation to ensure that all fixings and/or
Ratings
1. All luminaires are manufactured & tested in compliance with the requirement contained within BS EN 60598 and are CE marked.
2. All luminaires that are of Class 1 construction and that are marked accordingly, MUST be earthed.
3. All luminaires are designed to operate at 230Volts AC -6%/+10% = 216Volts to 252Volts. Do not operate outside these voltages.
4. All luminaires are only suitable for applications within their rated Ingress Protection limits as stated.
5. This luminaire is designed for internal use only.
Exclusions to Warranty
Please Note - The limited warranty shall be null and void in the following circumstances:-
Failure by the installer, end user or any third party to exercise caution to protect any covered product or part from outside
damage, adverse temperature (ambient temperature -25 - +50°C), humidity conditions, fluctuations in the electrical system or
physical abuse as well as failure related to workmanship in the installation of the products or parts.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Installation
suspensions are of a suitable size for the luminaire being installed.
Carefully remove the product from the packaging.
Select a suitable mounting surface.
Using allen key supplied, remove fixing bracket from the ceiling rose / housing. Position and fix the bracket to a suitable
solid surface using the wall plugs and screws provided.
Adjust the luminaire to desired mounting height removing any excess cable; ensuring strain relief is secure.
Terminate the supply into terminal block attached to the mounting bracket, taking care to observe correct polarity. THIS
LUMINAIRE IS CLASS I, THEREFORE MUST BE EARTHED.
Electrical Connections
Connect as follows:-
LIVE (L) BROWN OR RED (switched / dimmer)
EARTH GREEN / YELLOW
NEUTRAL (N) BLUE OR BLACK
Please note that this product is triac dimmable.
Secure the ceiling rose / housing to the fixed mounting bracket.
Ensure fixture hangs horizontal when suspended. Care should be taken to ensure luminaires are suspended from suitable
fixings to ensure installation is safe.
Restore mains supply, switch on and test for satisfactory operation.
Luminaire Code(s) – AJSLEDP/WW/W & B
IP20
-------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Maintenance:
1. This luminaire LED contains no serviceable parts.
Blue / Black
Brown / Red
Disposal of Electronic Equipment WEEE Directive 2002/96/EC
This product falls within the scope of the Waste Electrical & Electronic Equipment Directive
(WEEE), which means the product should not be disposed of as normal household waste.
Ensure that this luminaire and lamp is disposed of in accordance with the WEEE Directive.
Contact a local Council Waste Dept. Local Amenity Site, or the Environment Agency for
further information. RoHS - All components and materials used in this product are RoHS
2002/95/EC com
liant.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------Ansell Lighting Products, Unit 6B, Stonecross Ind. Park, Yew Tree Way, Warrington, WA3 3JD
www.anselluk.com
Loading...