Anker Technology A3234 User Manual

SoundBuds Flow

Owner’s Manual

Safety Instructions

① Avoid dropping.
② Do not disassemble.
③ Do not submerge in water.
④ The product shall not be exposed to dripping or splash.
⑤ Avoid extreme temperatures.
⑥ The battery shall not be exposed to excessive heat such as sunshine, fire or the like.
⑦ Use original or certified cables.
⑧ Do not use any corrosive cleaner/oil to clean.
⑨ Do not use the product outdoors during thunderstorms.
⑩ Keep out of reach of children. It contains small parts which may be a choking hazard.

Hearing Safety

① To avoid hearing damage, do not listen for extended periods at high volume.
② Do not turn the volume so high that you’re unable to hear your surroundings.
③ Do not use earphones while driving.
④ You should use caution or temporarily discontinue use in potentially hazardous situations.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures: (1) Reorient or relocate the
receiving antenna. (2) Increase the separation between the equipment and receiver. (3)
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected. (4) Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device can be used

in portable exposure condition without restriction.

On / Off

Flashing blue once

Press and hold for 1 second

ON

Flashing red once

Press and hold for 3 seconds

OFF

Charging