Andrew Wireless Innovations Group RPT-MR741 Antenna mounting information

User’s manual for channel selective repeater MRx41

User’s manual for

channel selective repeater

MRx41

Manual updatex41.doc Id.-No. 148092 Page 1 24-OCT-00

User’s manual for channel selective repeater MRx41

HEALTH AND SAFETY WARNINGS

Installer
Warning:

Any over the air radiated use of this product is intended to be used
with either Roof Top (Building-mount) or Pole Mounted (Non­building-mount) fixed Antennas.

Antenna installation must conform within the following guidelines to
meet FCC RF exposure limits, otherwise a environmental evaluation
is required if:

Broadband PCS (subpart E): Non-building-mounted antennas:
height above ground level to lowest point of antenna < 10m Radio
(Part 24) and total power of all channels > 2000 W ERP (3280 W
EIRP).

Building-mounted antennas: Total power of all channels > 2000 W
ERP (1640 W EIRP).

F

F

F

F

Note:

Note:

Note:

Note:

For any clarification, please refer to FCC rules, 47 CFR ch. I, part 1.1307

The electrical installation has to be performed in accordance with
the safety regulations of the local authorities. Due to safety reasons
the electrical installation must be performed by qualified personnel.
The cover of this unit should not be opened while power is applied.
Subsequent installation, commissioning and maintenance activities
that require the unit to be powered with the cover open shall only be
carried out by suitably qualified personnel.

The grounding of the Unit has to be performed by all means. A
grounding bolt is provided at the cabinet in order to connect the
earth bonding cable.

The Unit is heavy-weight. Make sure that a suitable mounting
surface is used. Only adequate manpower is allowed to handle the
system.

ESD precautions have to be observed! Before maintenance work use
the available grounding system to connect ESD protection
measures.

Manual updatex41.doc Id.-No. 148092 Page 10 24-Oct-00