Andrew Wireless Innovations Group RPT-MR703 Update to manual

WARNING INSTALLERS!

this device is in operation, a separation distance of at least 20 centimeters
must be maintained between radiating antennas and the body of the user
or nearby persons in order to meet the FCC RF exposure guidelines.

This device must be installed so that while

Appendix A : Installation Checklist

The following checklist provides a summary of the procedures for installing a MR703D system:
Step Ite m/ Ac ti on Description

1

2

3

4

5

6

7

8

9
10

11

12

MR703D Site Drawing

Equipment List: Quantity:

MR703D
AC Power Outlet
Coverage Antenna*
Donor A ntenna
50-ohm Donor Antenna Cable
50-ohm Do nor Jumper*
50-ohm Coverage Antenna Cable

Installation tools:

Cable connector Tools*
Multimeter
Handset with Power Indicator

Calculate RF Output Power (ERP) at
antennas for FCC RF exposure
complia nce.

Run Cable

Attach Connectors*

Verify “Donor and
CoverageAntennas ” locations are
consistant with RF exposure warning
(see above and below).
Record Serial Numbers and Locations
on site Drawing.
Mount the Equipment
Connect the 50-ohm Cables as shown
on the Site Plan

Supply AC Power, and commission
the System.
Check Power Levels



.

Master copy of the site plan noting the MR703D location and
serial number, and the location of the indoor coverage
antenna(s)). This should characterize the design parameters
for the system including cable paths and lengths.

Crimper, knife, etc.
To ensure no cable shorts.
To verify coverage after commissioning.

Installer must verify that the Output Power at the antennas is
less than 3W ERP, this must include cable loss and antenna
gain. For additional information, contact Mikom technical
support at (800)-800-7465

Install Cable in the site.

Measure across center pin and outer shell (ground) to ensure
no short.
Be sure to record the antennas location status for future
reference.

Note: this is to aid the Mikom Technical Support Specialists,

should you need their assistance.
Including indoor coverage antennas for metal case models.
Use caution when connecting semi-flexible cables to the
mounted MR703D and antennas. Excessive force on antenna
or MR703D connectors will result in serious equipment
damage.
Check the MR703D status as described in previous section .

Check power indication of handheld mobile at various
locations within the coverage area.

♦

As Required

*

WARNING INSTALLERS!

this device is in operation, a separation distance of at least 20 centimeters
must be maintained between radiating antennas and the body of the user
or nearby persons in order to meet the FCC RF exposure guidelines.

Appendix A : Installation Checklist:MR703D Users Guide Manual 149678 (m0041a3a, 6\00) Page A-1

This device must be installed so that while