Anchor TENT LINER User Manual

Assembly Instructions

Century Tent Liner

Please read all assembly / installation instructions before the installation or removal of this product.

PHONE: [phone]

SALES OFFICES:

1100 BURCH DRIVE

PO BOX 3477

EVANSVILLE, IN 47733 USA

Quality, Craftsmanship and Service since 1892

EC xxxx

FAX: [phone]

1-800-544-4445

EMAIL: [e-mail]

www.anchorinc.com

PRODUCTION FACILITY:

EVANSVILLE, IN

cenl 0109

Step 1 - Preparation

LINER RIGGING

The liner will be hoisted using liner rigging - see Figure 1.
Important: Before tent is raised, liner rigging must be slipped

over center pole pins. Note that on liners with 8” bale ring, only
one rigging is required per center pole. Liners with 10” bale
rings require two liner riggings per center pole.

Layout drop cloths before placing liner pieces on ground in their
proper positions - fi nished side down toward ground.

Step 2 - Lacing of Ridge on Double Center Pole
Tents

On double center pole tents, start lacing at center of ridge
between center poles. Fasten side-release buckles and menax
fasteners working toward center poles, fastening velcro from
menax fastener to menax fastener. If fullness occurs, try
stretching the shorter side to work in the fullness.

Step 3 - Bale Rings

Run bale ring through loops at center pole holes. See Figure 3.
8” Bale ring requires only one rigging assembly. 10” Bale ring

requires two rigging assemblies.

Top loops fit over
center pole pin. (Before
tent is raised.)

Pulley (typ.)

Pull rope (typ.)

For 8” Bale Ring

(1) per Center Pole

CENTER OF RIDGE

ON DOUBLE CENTER POLE TENT

For 10” Bale Ring

(2) per Center Pole

Figure 1

See fi gures 3 and 4 to see how liner riggings are attached to
bale rings.

Step 4 - Lacing from Center Poles down to Eave

Fasten side-release buckles and menax fasteners at bale ring.
Working toward eave, fasten velcro from menax fastener to
menax fastener. If fullness occurs, try stretching the shorter
side to work in the fullness.
Fasten velcro down to bottom of curtain.

8” Bale Ring

Wingnut

Bolt

Lanyard on pulley

Side Release Buckles
Menax fasteners

Velcro edges

Side Release
Buckles

Menax fasteners

Figure 2

10” Bale Ring

Fit bale ring halves
through rings in
liner riggings as
shown.

Figure 3

Figure 4