Anchor STAKE OUT User Manual

Assembly and Operation Instructions

Stake Out

Assembly Instructions Operating Instructions

Step 1

Step 2

Link
arms

Short bolt

Riser tube

Long
bolt

Step 1: Place contents

of box on floor or table. Place
handle over riser tube with de­cal facing up and insert short
3/8” - 24 bolt.

Step 2: Start 3/8” - 24

self-locking nut onto bolt.

Step 3: Swing link arms

up to handle. Insert the long
3/8” bolt through link arms and
handle.

Step 1: Lift handle to up position so that

jaws are fully open.

Step 2: Place unit so that jaws are on either

side of stake. See Figure 1 below.

Step 3: Push down on handle, clamping on

stake and lifting it out of the ground.

Step 4: Repeat motion as necessary until

stake is free

Tip: In soft conditions or mud, place a short

piece (1 to 2 feet in length) of 2 x 4 lumber under
the base of the unit. This will spread the force
over a larger area, allowing stake removal even
in muddy conditions.

Figure 1

Stake head adapter (optional) (for single head or

shoulder head stakes tamped down close to base plate.) Part #36574

Step 3

Step 4

EC 3845

Step 1

Step 4: Use two 9/16”

wrenches to tighten riser bolts
and nuts and link arms onto
handle.
Note: Nut will stop before
contacting the handle. Then,
back off the nut on the link
arm bolt one full turn from the
washer. Handle should raise
and lower freely.

Step 1: Remove pin at bottom of

riser tube. Raise the tube until holes
align and replace pin.

Step 2: Fit adapter over head of

stake and slide into small end of slot.

Step 3: Place unit so that jaws

are on either side of stake adapter bar
and continue as noted in Operating
Instructions.

CAUTION: Never put your fingers or hands between the jaws,

or between the jaws and the stake.

Anchor Industries, Inc. ● 1100 Burch Drive ● PO Box 3477 ● Evansville, IN 47733, USA

Phone: [phone] ● Fax: [phone] ● Toll Free: 800-544-4445

Email: [e-mail] ● www.anchorinc.com

Step 2

Step 3

ASO 1208