Anchor an130rc, an130ui, an130dc User Manual

TROUBLESHOOTING GUIDE

e

ANCHOR Audio, Inc. [phone]

100-0126-000 / Rev. A - 08/ 03

Having trouble with the sound system?

Condition Possible Solution

No sound (power LED not lit): • turn POWER switch on

• plug in power cord

No sound (power LED lights): • check for output from source

• make sure all cables are completely plugged in

• increase volume control

• press mute button on remote (AN-130RC only)

• turn power switch to off then back to on

(AN-130RC only)

Distorted sound: • check input cable connection

• lower input signal level

Excessive hum or noise: • use shielded input cable

Having trouble with the wireless system?

Condition Possible Solution

No sound: • confirm transmitter power switch is set to on

• turn up volume control

• plug microphone into body-pack transmitter

• turn sound system on

• replace mic/transmitter battery

• make sure collar, headband or lapel mic cable is

fully plugged into transmitter

• turn off mute by pressing, volume up,

volume down or mute (AN-130RC only)

Frequent transmitter dropouts: • replace mic/transmitter battery

• move mic/transmitter closer to AN-130

• change transmitter to different channel

AN-130

AN-130DC

AN-130RC

AN-130U1

Owner’s Manual

e

m

l

s

u

b

s

l

e

a

o

r

v

t

b

13

IMPORTANT SAFEGUARDS SPECIFICATIONS

CAUTION: To reduce the risk of electric shock, do not remove the cover. No user-serviceable

parts inside. Refer servicing to qualified personnel.

WARNING: To prevent fire or electric shock, do not expose this equipment to rain or

moisture.

CAUTION: To reduce the risk of fire, replace only with same type fuse (see specifications).

ATTENTION: Pour eviter les risques de choc électrique, ne pas enlever le couvercle. Aucun

entretien de pièces intérieures par l'usager. Confier l'entretien au personnel qualifié.

AVIS: Pour eviter les risques d'incendie ou d’électrocution, n'exposez pas cet article à la

pluie ou a l'humidité.

ATTENTION: Pour diminuer le risque d’incendie, remplacer par des fusibles de même type

(voir caractéristiques).

EXPLANATION OF GRAPHICAL SYMBOLS

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to

alert the user to the presence of uninsulated “dangerous voltage” within the product’s

enclosure that may be of sufficient magnitude to constitute a risk of electric shock to

humans.

The exclamation point, within an equilateral triangle, is intended to alert the user to the

presence of important operating and maintenance (servicing) instructions in the literature

accompanying the appliance.

EXPLICATION DES SYMBOLES GRAPHIQUES

Le symbole éclair avec point de flèche à l'intérieur d'un triangle équilatéral est utilisé pour

alerter l'utilisateur de la presence à l'intérieur du coffret de “voltage dangereux” non isolé

d'ampleur suffisante pour constituer un risque d'elétrocution.

Le point d'exclamation à l'intérieur d'un triangle équilatéral est employé pour alerter les

utilisateurs de la présence d'instructions importantes pour la fonctionnement et l'entretien

(service) dans le livret d'instruction accompagnant l'appareil.

DATE OF MANUFACTURE

The date of manufacture of this Anchor Audio product can be determined by the eight digit

serial number code. The fourth digit denotes the year, the third digit (letter) denotes the

month (A=Jan, B=Feb, etc.) Example: "AWDO1432" states that the unit was manufactured

in April of 2000.

Rated power output: 30 watts

Sensitivity for rated output:

Line: -20 dBV (100 mVrms)

Microphone: -43 dBV (7.5 mVrms)

Instrument: -30 dBV (30 mVrms)

Frequency response: 65 Hz – 18 kHz ± 3dB

Max SPL @ rated power: 101 dB @ 1 meter

Speaker type: 4.5 inch woofer, 10mm dome tweeter

Inputs

Line inputs (2): Hi-Z, unbalanced, RCA (summing L+R)

Microphone input: Lo-Z, unbalanced, 1/4"-phone

Instrument input: (3k), unbalanced, 1/4"-phone

DC output: 12 Volts DC, 100 mA max

RF Wireless Receiver: PLL Synthesized

Sensitivity: 2µV at S/N 40 dB

Frequency: 682.375 MHz - 697.125 MHz

AC Power requirements 110 - 125 VAC, 50/60 Hz

export model: 208 - 240 VAC, 50/60 Hz

(50 watts max)

Fuse rating: T 1.0A / 250V

export model: T 0.5A / 250V

(internally mounted)

Dimensions (HWD): 5.25 x 8.4 x 9", 13 x 21 x 23 cm

Weight: 8.5 lbs, 3.8 Kg

Specifications subject to change without notice.

12

NOTES

1

Quick Use Guide …………………………………… 2

Feedback Information ……………………………… 2

Getting Started ……………………………………… 3

General Operation ……………………………… 4-5

Wireless Operation ……………………………… 6-8

Wireless Remote Control ………………………… 9

Accessories …………………………………… 10-11

Specifications ……………………………………… 13

Troubleshooting Guide ………………… back cover

Thank you for choosing an Anchor Audio portable

sound system. Our products incorporate state-of-

the-art design and the finest quality of materials

and workmanship. We’re proud of our products and

appreciate the confidence which you have shown by

selecting an Anchor system.

I hope you’ll take a few of minutes to review this

manual. We’ve incorporated several unique features

into our products, and your knowledge of how to

use them will enhance the performance and your

enjoyment of the system.

David Jacobs, President

on behalf of all Anchor Employees

CONTENTS