Anatek Pocket Mapper User Manual

Pocket MAPPER™

BOB’S CHEAT SHEET

Pocket MAPPER™ can be used to map specific MIDI controller data to other MIDI controller data, thereby allowing you to
create custom MIDI setups, or use legacy devices with newer hardware.

CONNECTION DIAGRAM

a) Connect the MIDI OUT of a keyboard or other MIDI Device to the jack labeled “In” of the Pocket MAPPER™.
b) Connect the output jack labeled “Out” of the Pocket MAPPER™ to the MIDI IN of a synthesizer or sound module.

There are 8 on/off switches on the front panel of the Pocket MAPPER™, which are divided into two groups of four switches:

Switches Description

1 to 4 Specifies which controller messages will be mapped from the MIDI input

5 to 8 Specifies which controller messages will be mapped to the MIDI output

Each set of four on/off switches can be configured to map the following controllers:

Switches Description Switches Description

KEYBOARD

Bypass

Pitch Bend

Pocket

MAPPER™

SWITCHES

SYNTHESIZER

or MODULE

Volume (7)

Balance (8)

Aftertouch

Modulation Wheel (1)

Breath Controller (2)

Foot Controller (4)

Portamento Time (5)

Data Increment/Decrement (60/66)

Pocket MAPPER™ is a trademark of Anatek Microcircuits Inc.

Music Products Division

400 Brooksbank Avenue, North Vancouver, B.C. Canada V7J 1G9

PHONE: [phone] FAX: [phone]

Pan (10)

Expression (11)

Controller (16)

Sustain (64)

Soft Pedal (67)

Chorus Depth (93)