ANALOG DEVICES ADP199 Service Manual
3.6 V, 500 mA Logic Controlled
Data Sheet
FEATURES
Constant low RDSON of 40 mΩ over input voltage range
Low input voltage range: 0.9 V to 3.6 V
500 mA continuous operating current at 85°C
1.2 V logic compatible enable input
Low 6 μA quiescent current, independent of load current
Ultralow shutdown current: <100 nA
Ultrasmall 0.8 mm × 0.8 mm × 0.5 mm, 4-ball,
0.4 mm pitch WLCSP
APPLICATIONS
Low operating voltage processors
Mobile phones
Digital cameras and audio devices
Portable and battery-powered equipment
Optical XMT/RCVR modules
High-Side Load Switch
ADP199
GENERAL DESCRIPTION
The ADP199 is a high-side load switch designed for operation between 0.9 V to 3.6 V. A load switch provides power
domain isolation, thereby helping to keep subsystems isolated
and powered independently, and enabling reduced power
consumption.
The ADP199 contains a low on-resistance, N-channel MOSFET
to minimize power loss, and supports over 500 mA of continuous
load current. The low 6 µA quiescent current and ultralow
shutdown current make the ADP199 ideal for battery-operated
portable equipment. The built-in level shifter for enable logic
makes the ADP199 compatible with many processors and GPIO
controllers.
In addition to high performance, the ADP199 occupies minimal printed circuit board (PCB) space with an area of less than
0.64 mm
The ADP199 is available in an ultra-small, 0.8 mm × 0.8 mm ×
0.5 mm, 4-ball, 0.4 mm pitch WLCSP.
2
and a height of 0.50 mm.
TYPICAL APPLICATIONS CIRCUIT
VIN
+
–
GND
EN
ON
OFF
4Ω
CHARGE PUMP
AND SLEW RATE
CONTROL
ADP199
Figure 1.
VOUT
LOAD
09672-001
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Anal og Devices for its use, nor for any infringements of patents or ot her
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700 www.analog.com
Fax: 781.461.3113 ©2011 Analog Devices, Inc. All rights reserved.
ADP199 Data Sheet
TABLE OF CONTENTS
Features.............................................................................................. 1
Applications....................................................................................... 1
General Description ......................................................................... 1
Typical Applications Circuit............................................................ 1
Revision History ............................................................................... 2
Specifications..................................................................................... 3
Timing Diagram........................................................................... 3
Absolute Maximum Ratings............................................................ 4
ESD Caution.................................................................................. 4
Pin Configuration and Function Descriptions............................. 5
REVISION HISTORY
/11—Revision 0: Initial Version
Typical Performance Characteristics..............................................6
Theory of Operation ...................................................................... 11
Applications Information.............................................................. 12
Ground Current.......................................................................... 12
Enable Feature ............................................................................ 12
Timing ......................................................................................... 12
Outline Dimensions....................................................................... 14
Ordering Guide .......................................................................... 14
Rev. 0 | Page 2 of 16
Data Sheet ADP199
V
SPECIFICATIONS
VIN = 1.8 V, VEN = VIN, I
Table 1.
Parameter Symbol Test Conditions/Comments Min Typ Max Unit
INPUT VOLTAGE RANGE VIN T
EN INPUT
EN Input Threshold VIH % of VIN, VIN = 0.9 V to 3.6 V, TJ = −40°C to +85°C 65 %
V
EN Input Pull-Down Current IEN V
CURRENT
Ground Current I
V
V
V
Off State Current I
V
V
Continuous Operating Current I
VIN to V
RESISTANCE RDSON
OUT
V
V
V
V
V
TURN-ON DELAY TIME See Figure 2
OUT
Turn-On Delay Time t
V
TURN-OFF DELAY TIME See Figure 2
OUT
Turn-Off Delay Time t
= 200 mA, TA = 25°C, unless otherwise noted.
OUT
= −40°C to +85°C 0.9 3.6 V
J
% of VIN, VIN = 0.9 V to 3.6 V, TJ = −40°C to +85°C 25 %
IL
= 1.8 V 450 nA
IN
V
GND
VEN = GND, V
OFF-IN
V
OUT
VIN = 1.8 V, C
ON_DLY
VIN = 1.8 V, I
OFF_DLY
= 0.9 V 3 µA
IN
= 1.2 V 4 µA
IN
= 1.8 V, TJ = −40°C to +85°C 6 20 µA
IN
= 3.6 V 35 µA
IN
= 0 V 90 nA
OUT
= 0 V, VIN = 3.6 V, V
EN
= GND, TJ = −40°C to +85°C, V
EN
= 0.9 V to 3.6 V, TJ = −40°C to +85°C 500 mA
IN
= 0.9 V 0.04 Ω
IN
= 1.2 V 0.04 Ω
IN
= 1.8 V, TJ = −40°C to +85°C 0.04 0.09 Ω
IN
= 3.6 V 0.04 Ω
IN
= 4.7 µF 20 s
LOAD
= 10 mA, C
LOAD
= 0 V 165 nA
OUT
= 0 V 3 µA
OUT
= 4.7 µF 60 s
LOAD
TIMING DIAGRAM
TURN-ON
DELAY
90%
10%
TURN-ON
RISE
EN
TURN-OFF
V
OUT
TURN-OFF
Figure 2. Timing Diagram
DELAY
FALL
09672-002
Rev. 0 | Page 3 of 16
ADP199 Data Sheet
ABSOLUTE MAXIMUM RATINGS
Table 2.
Parameter Rating
VIN to GND −0.3 V to +4.0 V
VOUT to GND −0.3 V to VIN
EN to GND −0.3 V to +4.0 V
Continuous Drain Current
TA = 25°C ±1000 mA
TA = 85°C ±700 mA
Continuous Diode Current −50 mA
Storage Temperature Range −65°C to +150°C
Operating Junction Temperature Range −40°C to +85°C
Soldering Conditions JEDEC J-STD-020
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
Table 3. Typical θ
Package Type θJA ΨJB Unit
4-Ball, 0.4 mm Pitch WLCSP 260 58 °C/W
ESD CAUTION
and ΨJB Values
JA
Rev. 0 | Page 4 of 16
Data Sheet ADP199
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
12
VIN VOUT
A
EN
B GND
ADP199
TOP VIEW
(Not to Scale)
Figure 3. Pin Configuration
Table 4. Pin Function Descriptions
Pin No. Mnemonic Description
A1 VIN Input Voltage.
A2 VOUT Output Voltage.
B1 EN Enable Input. Drive EN high to turn the switch on and drive EN low to turn the switch off.
B2 GND Ground.
09672-003
Rev. 0 | Page 5 of 16
Loading...