AMX RDM-SWM User Manual

Installation Sheet

RDM-SWM Switch Module 2400 W

The RDM-SWM Switch Module is a 2400 W general purpose relay module built for economical switching of incandescent lamps, low-voltage transformers, switched fans and electrical outlets. It is designed for use with the RDA series of enclosures, in an AMX Lighting™ modular digital dimming system. The RDM-SWM uses a positive air gap type relay. This module's 120, 240, and 277 VAC ratings are CE, UL, and C-UL approved.

Mounting points

Line in (hot)

High-voltage connections

Load out

Relay A

Specifications

• Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)

• Non-phase dependant

• Use wires rated at 75°C (167°F)

• Torque terminals to 7 in-lbs. (0.8 N/M)

• Max. wire size: 10 AWG (4 mm²)

• Wire stripping length: 0.28" (7 mm)

• Weight: 0.5 lbs. (0.227 kg)

• BTU/hr: 5

• Control current: 85 mA @ 12 VDC

Caution: Pre-Installation Notes

• All Class 1 wiring must be connected to proper terminals.

• All control wiring must be connected to proper terminals.

• Disconnect power while installing or connecting the unit.

• Keep top and bottom air vents clear at all times.

• Test loads for shorts before connecting.

• Use low-voltage wires with a 300 volt rating or greater.

• Use field installed copper conductors.

• All electrical ratings are for continuous duty.

• For indoor use only.

• This module may require extra power from the AXlink connection or an external power supply connected to the control card.

Connecting the RDM-SWM to the AMX Lighting Master

Pin 4 (GND) Pin 3 (RLY)

Pin 2 (DIM)

Pin 1 (+12 V)

RDM-SWM 4-pin module connector

FIG. 1 RDM-SWM Switch Module

RDM-SWM UL and C-UL Ratings

• General purpose: 2400 W

• Resistive: 2400 W

• Ballast: 2400 W

• Motor: 277 VAC, 1 hp

Suggested Switched Loads

• Incandescent

• Low-voltage

• Motors

• Switched outlets

• Fluorescent

Low-voltage control wiring: 4-pin connector to AMX Lighting master controller

3 (-)

1 (+)

4-pin plug from RDM series module

NOTE: The 4-pin plugs from the module connector to the 4-pin connector on the master (black plug cover facing up).

FIG. 2 RDM-SWM connections

Lighting Application Drawings

FIG. 3 RDM-SWM Switch Module 2400 line wiring configuration

AMX Corporation reserves the right to alter specifications without notice at any time.

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).

The AMX logo is a trademark of AMX Corporation. AMX reserves the right to alter specifications without notice at any time.

3000 research drive, richardson, TX 75082 USA • 469.624.8000 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993