AMX warrants its products to be free of defects in material and workmanship under normal use for three (3) years from
the date of purchase from AMX, with the following exceptions:
•Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch
overlay components that are warranted for a period of one (1) year.
•Disk drive mechanisms, pan/tilt heads, power supplies, and MX Series products are warranted for a period of one
(1) year.
•AMX Lighting products are guaranteed to switch on and off any load that is properly connected to our lighting
products, as long as the AMX Lighting products are under warranty. AMX does guarantee the control of dimmable
loads that are properly connected to our lighting products. The dimming performance or quality cannot be
guaranteed due to the random combinations of dimmers, lamps and ballasts or transformers.
•Unless otherwise specified, OEM and custom products are warranted for a period of one (1) year.
•AMX Software is warranted for a period of ninety (90) days.
•Batteries and incandescent lamps are not covered under the warranty.
This warranty extends only to products purchased directly from AMX or an Authorized AMX Dealer.
All products returned to AMX require a Return Material Authorization (RMA) number. The RMA number is obtained
from the AMX RMA Department. The RMA number must be clearly marked on the outside of each box. The RMA is
valid for a 30-day period. After the 30-day period the RMA will be cancelled. Any shipments received not consistent
with the RMA, or after the RMA is cancelled, will be refused. AMX is not responsible for products returned without a
valid RMA number.
AMX is not liable for any damages caused by its products or for the failure of its products to perform. This includes any
lost profits, lost savings, incidental damages, or consequential damages. AMX is not liable for any claim made by a
third party or by an AMX Dealer for a third party.
This limitation of liability applies whether damages are sought, or a claim is made, under this warranty or as a tort claim
(including negligence and strict product liability), a contract claim, or any other claim. This limitation of liability cannot
be waived or amended by any person. This limitation of liability will be effective even if AMX or an authorized
representative of AMX has been advised of the possibility of any such damages. This limitation of liability, however, will
not apply to claims for personal injury.
Some states do not allow a limitation of how long an implied warranty last. Some states do not allow the limitation or
exclusion of incidental or consequential damages for consumer products. In such states, the limitation or exclusion of
the Limited Warranty may not apply. This Limited Warranty gives the owner specific legal rights. The owner may also
have other rights that vary from state to state. The owner is advised to consult applicable state laws for full
determination of rights.
EXCEPT AS EXPRESSLY SET FORTH IN THIS WARRANTY, AMX MAKES NO OTHER WARRANTIES,
EXPRESSED OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. AMX EXPRESSLY DISCLAIMS ALL WARRANTIES NOT STATED IN THIS LIMITED
WARRANTY. ANY IMPLIED WARRANTIES THAT MAY BE IMPOSED BY LAW ARE LIMITED TO THE TERMS OF
THIS LIMITED WARRANTY.
Table of Contents
Table of Contents
MAX Modules - Overview ...................................................................................1
NOTICE: MAX Products are not designed or intended to, and may not be used to, violate anyone’s
copyright or other intellectual property rights. Each user of the Products may only use the Products in
connection with materials legally owned or licensed by such user and only to the extent such ownership
or license rights permit such use.
This document describes the MAX-AOM (Audio-Only USB), and MAX-AVM (Audio/Video) and
Modules (FIG. 1).
MAX Modules - Overview
MAX-AOM Audio-Only (USB) Module
FIG. 1 MAX Modules
Refer to the MAX Servers Instruction Manual (available online at www.amx.com), as
well as the individual Installation Guides for details and installation instruction on
MAX Servers.
(FG 2178-55)
MAX-AVM Audio-Video Module
(FG 2178-50)
MAX AOM and AVM Modules
1
MAX Modules - Overview
2
MAX AOM and AVM Modules
MAX-AOM Audio-Only (USB) Module
MAX-AOM Audio-Only (USB) Module
Overview
The MAX-AOM Audio-Only Module (FIG. 2) is a streaming audio playback USB module that
distributes up to four stereo outputs (both digital and analog).
The AOM is available either as a single unit (FG 2178-55), or as two units using the optional AOM-EX
Expansion Kit (FG 2178-56) that mount side-by-side within a single rack unit. The AOM-EX adds
another four audio outputs, to allow up to eight audio-only outputs. Note that the AOM-EX does not
include a faceplate.
The MMS-01S, MMS-02S and MMS-02SB servers feature two built-in audio output
OUTPUT 2
channels, and support one MAX-AOM (for a maximum total of six audio output channels).
The MMS-04S, MMS-12S and MMS-900 servers support two MAX-AOMs (for a maximum
total of eight audio output channels).
Do not use a USB hub with MMS servers or AOM modules.
Product Specifications
(rear)
MAX-AOM (FG 2178-55) Specifications
Power:• 5VDC 0.9A external power supply
AC Current Draw (AMP): • .09A - Bootup/Power Cycle Peak
Audio Output:• 4 audio output channels, each with RCA SPDIF digital, analog stereo
MAX AOM and AVM Modules
• 110-240 VAC 50/60 Hz
• .09A - Normal Usage Peak
• Digital audio output: 6-channel Dolby Digital and DTS
• Analog audio output: stereo
• 24-bit D/A conversion, 128X over sampling
• 48kHz sampling rate
• Output level -10dBV nominal
• Signal to Noise Ratio 110db A-weighted
3
MAX-AOM Audio-Only (USB) Module
MAX-AOM (FG 2178-55) Specifications (Cont.)
Audio Output: (Cont.)• Frequency Response: 20Hz to 20kHz
Rear Panel Connectors:• USB Connector: USB connector (Type B)
Dimensions (HWD)• MAX-AOM (only): 1.75” x 8.48” x 10.47”
Weight:• MAX-AOM: 10.00 lbs (4.53 kg)
Included Accessories:• 5VDC 2.4A external power supply
Optional Accessories• AOM-EX Expansion Kit (FG 2178-56): includes a second MAX-AOM unit with
Certification:• FCC, CE
• Dynamic Range: 110dB
• Power Cable connector: DC 3-pin DIN.
• Audio Outputs: Four sets of three connectors (see FIG. 2):
• - (D): One RCA S/PDIF (coax) connector for digital output.
• - (L, R): Two RCA connectors for stereo analog output.
(4.44cm x 21.53cm x 26.59cm)
• Two MAX-AOM(s) with AOM-EX Rack Mount Kit:
1.75” x 19.1” x 12.02” (4.44cm x 48.51cm x 30.53cm)
• MAX-AOM-EX: 8.45 lbs (3.83 kg)
• 6’ (1.83m) USB (A to B) cable
• Removable Faceplate
mounting brackets and hardware.
Installing the MAX-AOM
Adding the MAX-AOM to the MMS Server
In order for AOM(s) to be recognized by the MMS server, they must each be added to the system, via the
Add Output Module options in the MAX Admin Menu. Add the AOM(s) to the server (as described
below) before physically connecting the module(s). Since AOMs provide up to four audio outputs per
USB port on the MMS server, each of the AOM audio outputs must be associated with a specific output/
zone on the MMS server:
The MMS-01S, -02S and 02SB servers feature two built-in audio outputs, which
occupy the first two outputs on (internal) USB 1 port for those servers. Refer to the
MMS-01S, -02S and -02SB Installation Guides for details on configuring the audio
outputs for external AOMs.
1. Open the System Information tab in WinMAX, and click on the Server Configuration button to
access the MAX Admin menu.
2. Go to Output Module Setup > Add Output Module > AOM to access the Enter Output Number
dialog.
3. Enter an available server output/zone number (between 1 - 33). This is the
Output Number that will appear in the WinMAX software.
The server will not allow you to assign an audio output to an output/zone that is
already in use. To determine which server outputs are already being used, select
View from the Output Module Setup menu.
If other output modules (AOM or AVM) have already been added to the server, then assign the
AOM to the next available output. For example, if you had already added 10 output modules
to the server, then this AOM should be assigned to output 11.
Note that AOMs use up to 4 outputs on the MMS server, while AVMs use only one.
4
MAX AOM and AVM Modules
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.