DATA SHEET
TM
Enova® DGX DXLink
AVS-ENOVADGX32-VI-DXLink (FG1058-570)
Twisted Pair Input Board
Overview
The AVS-ENOVADGX32-VI-DXLINK is a HDCP compliant twisted pair cable input
board for the Enova DGX 8, 16, 32 and 64 Digital Media Enclosures. It has four
connections per board designed to receive audio and video from DXLink Twisted
Pair Transmitters while passing bi-directional control and Ethernet signals over one
standard twisted pair cable up to 100m. DXLink Power is available from the DXLink
Input Board to power DXLink Twisted Pair Transmitters.
Common Applications
The Enova DGX DXLink Twisted Pair Input Board is ideal for applications where source devices are located up to
100 meters away from the Enova DGX Digital Media Switcher and need to be distributed throughout a commercial
or residential environment.
Features
Only One Cable – Receive audio and video while passing control, Ethernet and power over one twisted pair
cable
Send HDMI signals up to 100 Meters – Extend the reach of the HDMI with HDCP signals far beyond the
capabilities of typical HDMI cabling
Standard Twisted Pair Cable – Save time and effort in installation by leveraging pre-existing cost effective
twisted pair cable, see the Cabling for Success with DXLink white paper for more details
Hot Swappable – Easily add or replace I/O boards at any time after deployment - the system automatically
recognizes the new configuration and activates the boards
HDCP Compliant
© 2014 AMX. All rights reserved.
Additional Features
GENERAL
Compatible AMX Products
Must be used in conjunction with an Enova DGX 8, 16,
32 or 64 Digital Media Enclosure and a DXLink Twisted
Pair Transmitter
Compatible with all AMX DXLink Twisted Pair
Transmitters including HDMI Transmitter Module,
Multi-Format Decor Style Wallplate and Multi-Format
Wallplate
Recommended Accessories
•AVB-TX-MULTI-DXLINK DXLink Multi-Format
Transmitter (FG1010-310)
•AVB-DWP-TX-MULTI-DXLINK DXLink Multi-Format
Decor Style Wallplate Transmitters (US) (FG1010-325BL/WH)
•AVB-WP-TX-MULTI-DXLINK DXLink Multi-Format
Wallplate Transmitters (FG1010-320-BL/WH)
USB (HID) KEYBOARD & MOUSE
USB (HID)
Use the Enova DGX Digital Media Switcher in
conjunction with DXLink Transmitters and Receivers
(twisted pair and/or fiber), connect a DXLink
Transmitter to a PC and a DXLink Receiver to a
keyboard and mouse, the system then emulates
commands from the receiver back to the PC
For a list of HID devices which have been tested and
found to be working well with the latest firmware
please visit: http://www.amx.com/products/AVB-RX-
DXLINK-HDMI.asp and view the document “DXLink HID
Keyboard and Mouse Supported Devices”
Signal Transport – DXLink w/HDCP
Compatible Formats
HDMI Video / Audio / Ethernet / USB (HID) / Power
and Control
Signal Type Support
DXLink Twisted Pair
DXLink Twisted Pair Power
The DXLink Twisted Pair Input Board provides Power
over DXLink
DXLink Multi-Format Wallplate Transmitters require a
DXLink Power sourcing device, DXLink Transmitter
Modules can be powered via DXLink Power or desktop
power supply (ENERGY STAR® qualified) with power
cord
Remotely Powered Transmitters- Power over DXLink* is available from the DXLink Input Board to power
DXLink Transmitters
3D Support - Pass through latest video formats including 3D and Deep Color
Surround Sound Support – Pass through high definition surround sound including Dolby TrueHD, Dolby
Digital, DTS-HD Master Audio, DTS, 2 CH thorough 8 CH L-PCM
*Power over DXLink to DXLink Transmitters must be supplied by one of the following DXLink Power sourcing devices: Enova DGX 8/16/32/64
Digital Media Switcher (with a DXLink Twisted Pair Input Board installed), Compatible Enova DVX All-In-One Presentation Switcher (3155HD,
3156HD or 2155HD), PS-POE-AT-TC High Power PoE Injector or PDXL-2 Power over DXLink Controller. AMX only supports the use of these
approved Power over DXLink solutions. Other third party power supplies or non-compatible standard PoE solutions may damage the DXLink
equipment. The DXLink Transmitter Module can also be powered via the included desktop power supply (ENERGY STAR® qualified) with power
cord
Specifications
2
Approved Power over DXLink sourcing devices include:
•Enova DGX 8/16/32/64 Digital Media Switcher (with a
DXLink Twisted Pair Board installed)
•Compatible Enova DVX All-In-One Presentation
Switcher (3155HD, 3156HD or 2155HD)
•PS-POE-AT-TC High Power PoE Injector
•PDXL-2 Power over DXLink Controller
When installed in conjunction with an Enova DGX use
the Enova DGX Configuration Tool located at
AMX.com/enova to determine the power
requirements of the configuration
AMX only supports the use of these approved Power
over DXLink solutions. Other third party power
supplies or non-compatible standard PoE solutions
may damage the DXLink equipment. To use PS-POEAT-TC or PDXL-2 as a power source the wallplates
require firmware v1.2.40 or above
Use the Enova DGX Configuration Tool located at
AMX.com/enova to determine the power
requirements of a configuration and whether any of
the DXLink Transmitters or Receivers should be
powered with the local power supply. The
configuration tool contains instructions on how to
determine power requirements
Connectors
(4) RJ-45 Ports
Transport Layer Throughput (Max)
10.2 Gbps
Twisted Pair Cable Type
Shielded Cat6, Cat6A and Cat7
DXLink twisted pair cable runs for DXLink equipment
shall only be run within a common building where a
common building is defined as: the walls of the
structure(s) are physically connected and the
structure(s) share a single ground reference
For more details and helpful cabling information,
reference the white paper titled Cabling for Success
with DXLink, or contact your AMX representative
Twisted Pair Cable Length
Up to 328 ft (100 m)
Video Data Rate (Max)
4.95 Gbps / 6.75 Gbps
6.75 Gbps supported when the HDMI Output Board
Scaler or DXLink HDMI RX Scaler is in Bypass mode and
format is 1080p60 or less
Video Pixel Clock (Max)
165 MHz / 225 MHz
225 MHz supported when the HDMI Output Board
Scaler or DXLink HDMI RX Scaler is in Bypass mode and
format is 1080p60 or less
Progressive Resolution Support
480p up to 1920x1200 @ 60 Hz
Interlaced Resolution Support
480i, 576i, 1080i
Deep Color Support
24-bit, 30-bit, 36-bit
30-bit, 36-bit supported when the HDMI Output Board
Scaler or DXLink HDMI RX Scaler is in Bypass mode and
format is 1080p60 or less
Color Space Support
RGB 4:4:4
YCbCr 4:4:4 and 4:2:2
Input signal support for YCbCr 4:4:4 and 4:2:2, output
color-space is converted to RGB 4:4:4
3
3D Format Support
Yes (HDMI Primary Formats, when used with DXLink
Output Boards and the DXLink HDMI RX Scaler is in
bypass mode )
Frame Packing 1080p up to 24 Hz
Frame Packing 720p up to 50/60 Hz
Frame Packing 1080i up to 50/60 Hz
Top-Bottom 1080p up to 24 Hz
Top-Bottom 720p up to 50/60 Hz
Side-by-Side Half 1080i up to 50/60 Hz
Audio Format Support
Dolby TrueHD, Dolby Digital, DTS-HD Master Audio,
DTS, 2 CH through 8 CH L-PCM
Dolby Digital and DTS support up to 48 kHz, 5.1
channels
Audio Resolution
16 bit to 24 bit
Audio Sample Rate
32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 192 kHz
Local Audio Support
Yes, Insertion and/or Extraction of 2 CH L-PCM
selectable by channel when used in conjunction with
Enova DGX Audio Insert / Extract Board
HDCP Support
Yes, full matrix HDCP support (includes any input to
any or all outputs)
Key Management System
AMX HDCP InstaGate Pro Technology
Key support up to 16 sinks per output, independent of
source device
CEC Support
None
ICSP, TCP/IP, IR, Control Management
Control distribution is managed by the Enova DGX
8/16/32/64 Digital Media Switcher on-board NetLinx
Master and Ethernet Switch
DDC/EDID Support
EDID provided by the Enova DGX 8/16/32/64 Digital
Media Switcher to the connected DXLink HDMI TX,
EDID is user re-programmable
EDID – FACTORY LOADED1
Note
The default EDID can be overwritten to include a broad
range of features based on installation requirements
Standard Timing Identification
1920 x 1080 @60 Hz (This is the preferred format DTD
identified in the EDID)
1920 x 1200 @60 Hz
1680 x 1050 @60 Hz
1600 x 1200 @60 Hz
1600 x 900 @60 Hz
1400 x 1050 @60 Hz
1440 x 900 @60 Hz
1360 x 765 @60 Hz
1280 x 1024 @60 Hz
1280 x 900 @60 Hz
1280 x 800 @60 Hz
1280 x 720 @60 Hz
Established Timing
1280 x 1024 @ 75 Hz
1152 x 870 @ 75 Hz
1024 x 768 @ 60 Hz, 70 Hz, 75 Hz, 87 Hz
832 x 624 @ 75 Hz
800 x 600 @ 56 Hz, 60 Hz, 72 Hz, 75 Hz
720 x 400 @ 70 Hz, 88 Hz
640 x 480 @ 60 Hz, 67 Hz, 72 Hz, 75 Hz
CEA Video Information Code (VIC) Formats
VIC = 1, 640 x 480 p 59.94/60 Hz 4:3
VIC = 2, 720 x 480 p 59.94/60 Hz 4:3
VIC = 3, 720 x 480 p 59.94/60 Hz 16:9
4
VIC = 4, 1280 x 720 p 59.94/60 Hz 16:9
VIC = 5, 1920 x 1080i 59.94/60 Hz 16:9
VIC = 6, 720(1440) x 480i 59.94/60 Hz 4:3
VIC = 14, 1440 x 480 p 59.94/60 Hz 4:3
VIC = 15, 1440 x 480 p 59.94/60 Hz 16:9
VIC = 16, Native 1920 x 1080 p 59.94/60 Hz 16:9
VIC = 17, 720 x 576 p 50 Hz 4:3
VIC = 18, 720 x 576 p 50 Hz 16:9
VIC = 19, 1280 x 720 p 50 Hz 16:9
VIC = 20, 1920 x 1080i 50 Hz 16:9
VIC = 21, 720(1440) x 576i 50 Hz 4:3
VIC = 22, 720(1440) x 576i 50 Hz 16:9
VIC = 29, 1440 x 576 p 50 Hz 4:3
VIC = 30, 1440 x 576 p 50 Hz 16:9
VIC = 31, 1920 x 1080 p 50 Hz 16:9
VIC = 32, 1920 x 1080 p 23.97/24 Hz 16:9
VIC = 33, 1920 x 1080 p 25 Hz 16:9
VIC = 34, 1920 x 1080 p 29.97/30 Hz 16:9
VIC = 39, 1920 x 1080i 50 Hz 16:9
VIC = 41, 1280 x 720 p 100 Hz 16:9
VIC = 42, 720 x 576 p 100 Hz 4:3
VIC = 43, 720 x 576 p 100 Hz 16:9
VIC = 44, 720(1440) x 576i 100 Hz 4:3
VIC = 45, 720(1440) x 576i 100 Hz 16:9
VIC = 47, 1280 x 720 p 119.88/120 Hz 16:9
VIC = 48, 720 x 480 p 119.88/120 Hz 4:3
VIC = 49, 720 x 480 p 119.88/120 Hz 16:9
Audio Data Block
Basic Audio: 2 Channel L-PCM 32, 44.1, 48 kHz
Sampling Frequency at 16, 20 or 24 bits per sample
1
The default EDID can be overwritten to include a broad range of features, including HDMI mode, based on installation requirements
About AMX
AMX hardware and software solutions simplify the implementation, maintenance, and use of technology to create effective environments. With the increasing number of
technologies and operating platforms at work and home, AMX solves the complexity of managing this technology with reliable, consistent and scalable systems. Our award-winning
products span control and automation, system-wide switching and audio/video signal distribution, digital signage and technology management. They are implemented worldwide in
conference rooms, homes, classrooms, network operation / command centers, hotels, entertainment venues, broadcast facilities, and more. ©2014 AMX. All rights reserved.
Specifications subject to change. Revised 19-Feb-14.
AMX.com | 800.222.0193 | 469.624.8000 | +1.469.624.7400 | fax 469.624.7153
5
Loading...