Page 1
Installation Guide
DAS-LLC Line Level Converter
Overview
The Matrix Distributed Audio DAS-LLC Line Level Converter with Speaker Wire
Technology (FG1110-05) allows you to use an external power amplifier to power
the speakers in a zone, using Speaker Wire Technology™ (SWT) to the keypad
for control (FIG. 1).
FIG. 1 DAS-LLC Line Level Converter
Installation Instructions
1. Connect a small run of 16/4 between the zone output on the Matrix
Audio controller and the connector labelled “From Zone” on the
DAS-LLC.
2. Connect the 16/4 wire run from the zone’s keypad to the connector
labelled “To Keypad” on the DAS-LLC.
3. Connect a stereo RCA cable from the Left and Right RCA jacks
labelled “To Amplifier” on the DAS-LLC to the RCA inputs on the
external amplifier.
4. Connect a small run of 16/4 between the output of the external amplifier and the connector labelled “From Amplifier” on the DAS-LLC.
Wiring Diagram
FIG. 2 DAS-LLC Installation Diagram
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
5/08
©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-1110-01 REV: B
Loading...