AMX CC-NIRC Installation Guide

Installation Guide

REV: B93-0011-11

Opaque IR Window Shield

CC-NIRC Cable

IR Emitter Shield covering the IR Window on Controlled Device

CC-NIRC

CC-NIRC NetLinx IR Emitter Cable

Overview

The CC-NIRC (FG10-000-11) is an IR emitter cable used with NetLinx
controllers to control your equipment either from IR emitters or a hand-held
remote control. Utilizes a 2-pin, 3.5 mm Phoenix connector on one end and
a single LED emitter (flasher) on the other end.

FIG. 1 CC-NIRC

One black adhesive backed IR window shield is included. With this shield
surrounding the internal emitter, you can restrict IR reception through the
device’s control window by blocking any interference or IR signals
produced by sources other than the internal emitter. Without this shield,
any incoming IR signal can pass through to the IR control window and
overlap signals sent via the emitter. See Shielded Configuration for details.

Note: Clean the surface of the IR window of your equipment and make
sure it is free of any residue or contaminants before attaching the IR
emitter.

Pass-Through Configurations

This method allows IR signals generated from hand-held remotes to easily
pass through the opaque red shell/cover. The internal IR LED can be
oriented to either face towards or away from the shell, depending on its
output configuration.

• Use the low-output configuration when device is being saturated by an
IR signal.

• Use the high-output configuration when the device isn’t receiving
enough of an IR signal and requires more strength. The side with the
round “bump” is the high-output side.

Removing the Factory-Installed Shell

The factory-installed shell is easily removed by carefully separating the two
halves with a sharp-edged tool.

The IR LED can then be reversed or removed when the shell is separated.

Once the IR emitter and/or shield installations have been completed, the
housing can be re-assembled by pressing the two halves firmly together.

FIG. 3 Removing the Factory-Installed Shell

Shielded Configuration

Use this configuration to prevent interference from fluorescent lights or
other IR sources. The metallic shield prohibits passage of external IR
signals and ensures proper IR signals will be received from the emitter.

Opaque IR Window Shell

1. Remove the IR LED from the factory-installed shell.

2. Test fit the location and size of the IR shield on the target device. If
necessary, use scissors to trim the shield to fit the opening of the IR
window.

3. Remove the adhesive backing from the IR shield and carefully place
the IR LED into the recessed area using the correct orientation. Make
sure the wires attached to the IR LED are not shorted together.

4. Flip the shield-emitter combo back over and begin to carefully position
the shield over the IR control window so that it covers the entire sur­face. This keeps any other signal from coming through.

5. Press firmly on the shield surface to activate the pressure-sensitive
adhesive.

FIG. 2 Low-Output and High-Output sides

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).

©2012 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax [phone] • technical support 800.932.6993 • www.amx.com

AMX reserves the right to alter specifications without notice at any time.

Example CC-NIRC Installation

8/12