Amphony T800 Users Manual

User and Installation Guide

Multi-Channel Audio Transmitter

Model T800

Contents

Unpacking
Connecting the transmitter
Placing the transmitter
Pairing the transmitter and wireless devices
Troubleshooting
Technical specifications
Safety information
Limited Warranty

................................................................................. 3

........................................................ 3

............................................................... 7

......................................................................... 9

........................................................... 11

................................................................... 12

..................................................................... 14

............................. 7

User and Installation Guide User and Installation Guide

Unpacking: Check that this package contains:
One iFinity Digital Audio transmitter - Model T800, one 7.5 V AC adapter (wallwart),

four short speaker cables, two audio cables.

Connecting the transmitter

The transmitter has two stereo audio inputs, one zone-A and one zone-B input.
4 audio channels can be transmitted simultaneously. Both zone-A and zone-B audio
inputs can connect either to an unbalanced line-level audio output or a balanced
amplified speaker output. For best audio quality, we recommend using the
unbalanced line-level audio input.

The transmitter can transmit to iFinity wireless audio receivers such as Model R800
wireless audio receiver and Model 880 wireless amplifier. It is also compatible with
iFinity wireless speakers. Note: Zone-B audio channels can only be received by the
Model R800 and Model 880 audio receivers.

Connect the transmitter to an unbalanced audio input by using the supplied phone­RCA audio cable. Connect the phone jack with the line level input of the transmitter
and the RCA jack with the RCA output of your audio source.

Alternatively, connect the transmitter to an amplified speaker output by using the
supplied speaker cables. Be sure to observe the correct polarity of the speaker
cable. If one of the speaker cables is switched (reversed), one speaker will receive
an opposite polarity signal which will degrade sound performance.

Connect the supplied small AC adapter’s barrel-shaped plug into the DC 7.5V jack,
and then plug the transformer into a standard AC outlet. We recommend the use of
a surge protector to protect the transmitter from power surges.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.

Page 3