Amphony RX1, TX1 User Manual
User and Installation
Guide
DIGITAL Wireless
Audio Transmitter / Receiver
Model TX1, RX1
R
User and Installation Guide
Unpacking: Check that this package contains:
One audio transmitter, one audio receiver, two AC adapters, two audio cables.
R
Step 1
Connecting the transmitter
With the transmitter, you can send music from your iPod / iPhone or from any
audio source that either provides a line-level audio signal or amplified speaker
level signal.
Depending on what type of audio signal you wish to transmit, follow one of the
below guidelines:
a) Transmit music from an iPod / iPhone
Place your iPod or iPhone into the iPod cradle located at the top of the
transmitter. Ensure the iPod / iPhone display faces towards the front of the
transmitter.
b) Transmit music from a line-level audio source
Attach the small silver jack of the supplied Y adapter audio cable to the line
level audio input of the transmitter. Then connect the two RCA plugs to your
audio source.
c) Transmit music from an amplified source
In order to transmit music from an amplified audio source, attach the two
supplied speaker cables to the speaker outputs of your source and then to the
speaker jack of the transmitter. Please ensure the correct polarity of the cable.
The transmitter can also be connected to other audio outputs by using an
appropriate adapter.
Finally, connect the supplied small AC adapter’s barrel-shaped plug into the
DC 9V jack, and then plug the transformer into a standard AC outlet. We
recommend the use of a surge protector to protect the transmitter from power
surges.
Page 2
User and Installation Guide
R
iPod
AC adapter
Power outlet
Example: Transmitting music from an iPod
Page 3
DC 9 V
User and Installation Guide
L R
LINE OUT
R
Y adapter cable
Audio Source
AC adapter
DC 9 V
Power outlet
Example: Connecting the transmitter to a line-level audio source
Page 4
User and Installation Guide
Audio
Source
R
L R
SPEAKER OUT
AC adapter
DC 9 V
Power outlet
Example: Connecting the transmitter to an amplified audio source
Page 5
User and Installation Guide
R
Step 2
Connecting the receiver
The receiver connects to a line-in interface of an active speaker or external
amplifier via the supplied RCA cable.
If no line-in interface is available, the receiver can also be connected to other
audio inputs by using an appropriate adapter. It should be noted that the
maximum audio level of the receiver output is 1 Vrms (V ± 1.4 V maximum).
pp
Ensure that the connected audio device will accept this audio level.
Connect the DC power input with the supplied AC adapter. The use of a surge
protector is recommended to protect the receiver from power surges which
may damage the receiver or may cause audio dropouts.
Receiver
L R
DC 9V
AC adapter
Page 6
AUDIO
LINE IN
L R
Audio Input
(Active speaker)
DC 9 V
Power outlet
Loading...