Page 1
304
Amphenol Corporation Tel: 800-627-7100 www.amphenolrf.com
Step 1A
Step 1B
Step 2
Step 3
Step 4
Step 1A For all connectors except 31-4541-RFX (see step 1B).
Slide clamp nut over cable. Strip cable to dimension
shown. Cut braid and dielectric square. Do not nick
center conductor.
Step 1B For 31-4541-RFX.. Same as step 1A except use Step 1B
strip dimensions, and then slit jacket back .125"(3.2 mm) in
four places 90° apart as shown in illustration.
Step 2 Slide contact assembly under braid and jacket until braid
butts as shown. Use caution that braid slides over contact
assembly and not inside of it. Be sure center conductor
is visible through side hole of contact. Solder contact to
center conductor. Contact may be crimped on applicable
connectors using Amphenol CTL-1 crimp tool; or by using
die set 227-1221-13 cavity B in tool frame 227-944 or
equivalent tool
.
Step 3 Insert into connector body.
Step 4 Tighten clamp nut to a torque of 35 lbf-in.
clamp nut contact assembly plug body
Amphenol Connector Cable
Center Contact Affixment
Number Type RG-/U
Hex Size
Die Set for CTL Series
Tool 227-944* Tool Number
31-4541
BNC Plug 59, 59A, 62, 62A
31-4541-RFX
31-4542 BNC Plug Belden 9268
.068(1.7)
227-1221-13
CTL-1
Montrose CBL-5098 Cavity B
31-30220-1 BNC Plug 58
31-30220-8 BNC Plug 223
* for pneumatic crimp tool 227-60, use die sets indicated in this column
.250
(6.4)
.338(8.6)
.275(7.0)
.216
(5.5)
Assembly Instructions-C29 Amphenol
®
BNC
QUICKTRIM®PLUG
Loading...