Retro-Fit Manual
www.amico.com
Puritan-Bennett Gas Control Panel
Important Note
Due to unknown factors of the existing equipment, projects requiring Retro-Fit Conversions must be fully investigated by
the installer.
It is the responsibility of the installer to determine if the Retro-Fit will function correctly and if additional components are
required. Amico is not responsible for any additional components required.
Retro-Fit Instructions
Remove the screws from the Puritan-Bennett Gas Control
Panel.
Remove all internal components.
2 Amico Pipeline
Retro-Fit Instructions
Mount the ller frame to the wall using the appropriate
hardware. There are 6 holes provided for mounting the
frame.
NOTE: The frame can not be mounted on the wall centered
on the existing back box. The retrot is shipped with the
ller frame attached to the control panel. Before you take
these apart, push the assembly into the existing back box
and position it into place and mark o the corners of the
frame on the wall. These lines will be your reference for
mounting the frame to the wall.
Install the male elbows into the threaded connections in
the back box. Connect the input tube into the appropriate
tting in the box as shown.
Push the whole assembly gently into the back box and
secure the panel to the ller frame using the #8 stainless
steel machine screws provided with the kit. Please note the
position of the pigtails.
www.amico.com 3
www.amico.com
Amico Pipeline | www.amico.com
85 Fulton Way, Richmond Hill
Ontario, L4B 2N4, Canada
71 East Industry Court, Deer Park
NY 11729, U.S.A
Toll Free Tel: 1.877.462.6426
Toll Free Fax: 1.866.440.4986
Tel: 905.764.0800
Fax: 905.764.0862
Email: info@amico.com
APEOMRTRFTGASCTRLPNLPB 12.16.2013
Loading...