Amico NCG Chemetron Retro-Fit Outlet User Manual

Retro-Fit Manual

www.amico.com

NCG Chemetron

Important Note

Due to unknown factors of the existing equipment, projects requiring Retro-Fit Conversions must be fully investigated by
the installer.

It is the responsibility of the installer to determine if the Retro-Fit will function correctly and if additional components are
required. Amico is not responsible for any additional components required.

Existing NCG

Retro-Fit Instructions

Step 1:

Remove all secondary check parts from the
existing outlets. Replace the NCG rubber seat with
Amico #15 O-Ring.

Rough-In

Step 2:

Thread the Amico Retro-Fit rough-in assembly to
the existing NCG rough-in.

O-VC-OH1-TOOL

Amico Tool

Hole for Screw Driver
(to loosen & tighten)

NCG Original Rubber
Seat (to be removed &
replaced by #15 O-Ring)

Existing NCG
Rough-In

O-Ring
(H-ORING-015VTN)

Back Rough-In
Assembly Kit
(O-VC-NCG-U-GAS)

2 Amico Corporation

Retro-Fit Instructions

Step 3:

Use the rivet provided to attach the upgrade
bracket to the existing console to ensure it is
gas-specic.

Note: Ensure the Amico rough-in and the NCG
rough-in are the same gas.

Step 4:

Place the pre-assembled ller frame and face
plate over the wall outlet and insert the latch
valve assembly through the face plate and
fasten with the latch valve screws.

Existing NCG
Rough-In

Aluminum Rivet

(H-RIVIT-H-W-END)

(H-RIVIT-H-W-END)

#6-32 Screw
(H-MPF-0612)

Latch Valve Screw
(H-1612-06-18A)

Existing NCG
Rough-In

Filler Frame
(O-CON-FIL-PB500)

Chromed Faceplate
(O-TRIM-M500C)

Front Latch Valve
(O-FASC-QD-U-GAS)

www.amico.com 3

www.amico.com

Amico Corporation | www.amico.com

85 Fulton Way, Richmond Hill

Ontario, L4B 2N4, Canada

Toll Free Tel: [phone]
Toll Free Fax: [phone]
Tel: [phone]

Fax: [phone]
Email: [e-mail]

APEIMRETROFITNCGCHEMETRON 11.18.2014