Amico GoLimb Sling Instructions

BasicGo
LongGo

ActiveGo
ComfortGo

HygieneGo

CustomGo

TrackGo
LimbGo

Sling Instructions

Purpose and Use

The GoLimb sling is suited for lifting or supporting legs.

Instructions:

Do not place the GoLift system in the control of persons who have not received proper
training in its operation. Serious injury can occur if the GoLift system is used improperly.

Read and understand all instructions regarding the operation of the GoLift system prior to
use. Follow these instructions to ensure the safety of both the caregiver and the patient:

1. Use the proper size of sling on the patient.

2. Do not, under any circumstances, exceed the GoLift’s and sling standard working load.

3. Perform a visual inspection of the sling for signs of wear. Look for fraying, cuts or tears
in the material on both the slings body and straps prior to using the sling.

4. Remove and replace the sling if any damage is found on the sling.

5. Position the sling properly under and around the patient, to ensure a balanced lift.

6. The GoLift system must not be used for unsafe practices.

In facilities when more than once sta is responsible for operating the GoLift system, it is imperative that all such members are trained in its
proper use. A training and orientation program should be established by the facility to familiarize new caregivers with the GoLift system.

Plan the move. Avoid leaving the patient in the sling unattended. Do not start to lift the patient until it has been checked that the patient cannot
get trapped and that the sling does not catch on the bed or wheelchair. Be careful with any tubes and wires that are attached to the patient
and/or equipment.

Amico Mobility shall not be liable for faults or accidents due to incorrect use of the sling or for reasons of inadequate attention on the part of
the caregiver or user. If the sling is used in combination with products not manufactured by Amico, a risk assessment must be conducted by
qualied sta.

Attaching the lifting sling:

Place the straps from the lifting sling on the hooks on the carry bar. Start with the shoulder
straps (from the back) and then place the loops of the leg straps on the hooks of the carry bar.

Be careful when attaching the lifting sling on the hooks. Check that the straps have
been completely through the opening and into place in the carry bar hooks. When

!

pressing the up button to lift the patient, check again that all straps remain correctly
placed in the carry bar’s hooks.

176° F

80°C

MAX LOAD: 600 lbs (272 kg)

Insert the sling into a washing/laundry bag prior to being placed in the washer.
This is to prevent any unusaul wear and tear of the sling from the washing machine.

BasicGo
LongGo

ActiveGo
ComfortGo

HygieneGo

CustomGo

TrackGo
LimbGo

Sling Instructions

Placing the Sling from the Bed Placing the Sling from the Wheelchair

1. The GoLimb sling is placed under the
lower leg, where it is most appropriate
for the care task to be performed. To
lift the leg with the hip and knee bent,
place leg under upper portion of the
calf below the knee; to lift the leg with
the knee straight, place the sling under
lower parts of calf above the ankle.

2. The GoLimb sling is pulled under
the leg, taking care to keep a hand
between the sling fabric and the
patient’s skin, and is placed under the
lower lef, so that even amounts of sling
are on each side.

1. The GoLimb sling is lead under the
thigh at the back of the knee joint.

2. The GoLimb is pulled through, taking
care not so shear the user’s skin, so that
the sling is evenly placed with equal
amounts of sling fabric on both sides
of the leg.

3. The GoLimb sling is now connected to
the carry bar.

3. The GoLimb is pulled through, taking
care not so shear the user’s skin, so that
the sling is evenly placed with equal
amounts of sling fabric on both sides
of the leg.