Amico Gas Control Panel User Manual

Operating & Maintenance Manual

www.amico.com

Gas Control Panel

Contents

Intended Use/Introduction 3

Operation 4

Installation 4

Parts List 4 - 5

Notes 6 - 7

2 Amico Pipeline

Intended Use

The Amico Gas Control Panel is designed to deliver Nitrogen or Instrument Air to turbo-surgical tools.

Introduction

The Gas Control Panel consists of a shut-o valve, delivery and supply pressure gauges, pressure regulator and DISS
outlet, in addition an outlet pipe is supplied that can be piped to additional gas outlets.

The Gas Control Panel comes in two styles: “Relieving” and “Non-Relieving”. A relieving panel allows gas to vent from the
regulator, to reduce the pressure from the outlet pressure side of the panel. CSA requires that a non-relieving panel be
used where CSA Standards are practiced.

www.amico.com 3

Operation

1. Turn the Shut-o valve to the “Open” position.

2. Verify that the correct supply pressure is available on the supply gauge.

3. Attach a tool to the DISS outlet and tighten the nut (do not over tighten) or HP “Safety-Swing Coupling” outlet.

4. Adjust the pressure regulator to the required pressure by observing the outlet gauge.

5. Operate the surgical tool and observe the outlet pressure and adjust if needed.

6. When the control panel is not in use, reduce the outlet pressure to “zero” and turn o the supply valve.

Installation

Mount the back-box into the wall and adjust the adjustable side mounting brackets so that the top of the box will be
ush with the nished drywall. Connect the inlet pipe to the gas pipeline and the outlet to additional outlets (optional).
The pipeline can now be pressure tested to the required testing pressure. The outlet high pressure hose is shipped with
one end connected to the outlet and the other end connected to the inlet on the nitrogen back box. This will enable the
installer to pressure test the complete pipeline, including remote outlets, without having to attach the front assembly.

To attach the control panel front assembly to the control panel back box, you must rst disconnect the braided hose
from the male PT adapter that is attached to the inlet pipe on the control panel back box. Then loosen and remove the
panel cap from the male PT adapter that is marked “output” on the back of the control panel front assembly. Attach the
braided hose from the back box to the male PT adapter (avoid over tightening). Connect the “input” braided hose from
the back of the control panel front assembly to the “input” of the male PT adapter in the back box (avoid over tightening).
Mount the control panel front assembly to the back box with the enclosed machine screws.

Parts List

Nitrogen control panel English DISS (Relieving type) N-CONP-E-REL

Nitrogen control panel English DISS (Non-Relieving type) N-CONP-E

Instrument Air control panel English DISS (Non-Relieving type) N-CONP-E-I

Instrument Air control panel English DISS (Relieving type) N-CONP-E-REL-I

4 Amico Pipeline

Diagrams

1

10

13

11

12 Not visible

9 8 7 6

1

2

3

4

5

Disconnect Here

Gas Inlet Gas Outlet

Adjustable

Mounting Bracket

15

14

16

Item Description Part Number Item Description Part Number

2 1/2" Gauge, 0-400 psi, 1/4"

1

2

Center Back Mount
Brass Tee 1/4" FNPT

* 3/8" Tube

M-X-MAN-52B 9 Elbow 90° 1/4" MNPT * 1/8" Tube N-X-ELB-ALM2508

N-X-TEE-AL-F304 10 Elbow 90° 1/4" FNPT * 1/8" Tube N-X-ELB-ALF2508

3a. Regulator Relieving N-X-REG-W-HP-R 11. Elbow 90° 1/4" FNPT * 3/8" Tube N-X-ELBOW-AL

3b. Regulator Non-Relieving N-X-REG-W-HP 12a.

4 Shut-o Valve (Brass) N-X-VALVE 12b.

5

6

7

Elbow 90° 3/8" MNPT

* 3/8" Tube

Brass Tee 1/4" FNPT

* 3/8" Tube

Connector 3/8" MNPT

* 3/8" Tube

N-X-ELBW-AL-M37 13 Elbow 90° 1/2" MNPT * 3/8" Tube N-X-ELBW-AL-305

N-X-TEE-AL-F304 14

N-X-CON-AL-375 15

DISS Demand Check Valve

1/4" MNPT - Nitrogen

DISS Demand Check Valve

1/4" MNPT - Instrument Air

18" Long Braided Pigtail

(3/8" Inner Diameter)

Pigtail/Pipe Adapter for

Nitrogen Control Panel

S-DIS-DEMC-NIT

S-DIS-DEMC-IAIR

N-X-PIGTAIL

N-X-PT-ADAPTER

8 Bushing 1/2" * 3/8" N-X-BUSH 16 Box for Nitrogen Control Panel N-X-BOX

www.amico.com 5

Notes

6 Amico Pipeline

Notes

www.amico.com 7

www.amico.com

Amico Pipeline | www.amico.com

85 Fulton Way, Richmond Hill

Ontario, L4B 2N4, Canada

Toll Free Tel: [phone]
Toll Free Fax: [phone]
Tel: [phone]

Fax: [phone]
Email: [e-mail]

APE-OM-GAS-CTRL-PNL 06.20.2014