Amico Artwall User Manual

Installation Instructions

Reection Series Artwall

Corporation

Note

ArtWall installation should conform to local building codes

The installation instructions provided are for the Amico standard products. Slight modications
to the installations may be required. The product shipped to the job site may not be exactly as
shown on the installation drawings.

Before Installation

Review a copy of the nal approved shop drawing(s) and/or submittal package. These docu-

1.
ments will include technical information specic to the installation, such as:

- equipment types & quantities

- room numbers and location

- shop drawings of each unit type

- wiring diagrams and rough-in locations

2.

Locate the headwall unit from the shipping boxes.
The contents of each shipping box are listed on the shipping document(s).

3.

Ensure wall is framed and roughed in as per applicable building standards to accept art wall
back box. Allow 1/8” space on each side to allow for adjustment. Back box sizes are as follows:

3-gas box - 30 1/8 w x 21 1/8 h
5-gas box - 42 5/8 w x 21 1/8 h

note: vertical studs face each other

Typical example of 3-gas box with 3 gases

2 Amico Architectural

top view

Attach art wall back box to wall structure using hardware compliant to applicable

1.
building codes. Allow gap between back box ange to stud faces for drywall to be
attached later.

wall structure

artwall back box

gap for drywall

www.amico.com 3

Make all medical gas connections from art wall to rough-ins. Medical gas pipes are terminated

2.
as per shop drawings.

typical gas termination
location on artwall

Insert art into frame, then attach frame to backing plate and movement assembly, using hard-

3.
ware (provided by others). Ensure frame is centered on backing plate. Place assembly in a safe
location.

Note: At this point, it is recommended for the wall to be nished, before proceeding. This will
minimize interference of unit with trades, and keep remaining parts clean.

4 Amico Architectural

Attach frame and movement assembly to back box using hardware provided at loca-

4.
tions shown. Move frame as necessary to reach all of the hardware.
Tighten whiz ange screws using a 5/16” wrench.

screw locations

Note: Frame shown removed to show parts behind. Do not remove!

www.amico.com 5

www.amico.com

Amico Architectural | www.amico.com

85 Fulton Way, Richmond Hill

Ontario, L4B 2N4, Canada

71 East Industry Court, Deer Park
NY 11729, U.S.A

Toll Free Tel: [phone]
Toll Free Fax: [phone]
Tel: [phone]

Fax: [phone]
Email: [e-mail]

INSTALL INSTR. ARTWALL 10.25.2013